31AM5CP3766 (2021) Troy-Bilt Snow Blower - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- John from HARRISVILLE, NH
- Parts Used:
- 790-00121-0637
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Wrench set
Original shave plate badly worn
With WD-40 or equivalent, spray the four nuts on the underside of the snow blower housing that hold the shave plate to the housing. Also spray the two bolts that hold the shave plate to the side of the housing. Let sit for a few minutes and using a 1/2" box end wrench remove the four nuts on the bottom of the housing. If necessary, apply heat with a torch to loosen. Using a 9/16" box end wrench, remove the nuts on the sides (these also hold the adjustable skid feet). It is recommended that the bottom bolts and nuts be replaced with 5/16-18 X 3/4" long zinc plated carriage bolts using zinc plated washers and ny-lock nuts. It is also recommended that all of th screw threads be coated with an anti- seize lubricant so disassembly at a later date will be easy.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Jeffrey from MASSAPEQUA, NY
- Parts Used:
- 731-06113
- Difficulty Level:
- Easy
- Total Repair Time:
- 30 - 60 mins
Broken Steering Trigger on right side
If the trigger is broken on the left side, it is really easy to replace, if broken on the right side like mine the snow chute joystick control is in the way. Just remove the cover under the joystick and then the large nut under the joystick then you will be to push the joystick down giving you access to the pin that holds the steering trigger.
Was this instruction helpful to you?
Thank you for voting!