7WF736SDAM13 Whirlpool Refrigerator - Instructions

Remove torn old gasket.
Starting with bottom slid the gasket retainer under the door retainer lip on bottom. Repeated for top. Slid the retainer under the open side door retainer lip. Then pushed the gasket as much as possible to hing side. The slid the gasket retainer under the door retainer lip.

The switch fix but did not fix the problem. I assumed the wires go on the same way as on the old switch. Is it possible if one light Burns out, the other will not work either?

Pried out old part with screwdriver. Unplugged. When new part came, just plugged it in and pushed the part into place.

Popped out the old switch and replaced it with the one dying

Once I got a part that wasn't broken in transit (took them sending it 3 times for that to happen), it was a breeze. Remove old drawer, take tracks off old drawer and place on new drawer. Put new drawer in fridge.

Removed old door. Attached new door to two tabs. Done

Simply pulled out the old unit and installed new per instructions. I was going to order just the part that houses the auger and ice bucket. I was also going to purchase the lesser quality brands at deep discount but after ready the 'challenges' with all of that - spent the money and saved myself the headaches. (and scratched fingers) Easy peasy.

Simply placed on the front

Simply replaced the Ice Maker container

bulbs were not burnt out. received the new switch in a few days. watch the short video, was good to see how it comes out. used a putty knife to release the defective switch, removed wires put them on the new one and posed the new switch back in. Not bad Part cost $11.00 7 dollars shipping so for 17 bucks it works great. nice to see what is inside the refer!

Had to push the light switch to get lamp to light up.
Removed power from refrig. and removed old light switch
and replaced with the one I got from Partselect. Turned power back on and was done.

I found the web site and the pictorial schematic of the refrigerator but it really didn't show the part as well as I had hoped, so I called the toll free Partselect number and spoke with a representative who took down all of the information and told me the part would be shipped out in a few days. Well, low and behold the next day Fedex was delivering this ling box to my door-I carefully opened it-it was the front cover plate of the drawer BELOW the broken one-perhaps my mistake in explaining it properly over the telephone-so back to the toll free number to try and straighten out the problem and reorder the correct part-that was even simpler than the first call-the correct part was ordered, return Fedex paperwork was sent to me via email, and several days later the correct part did indeed arrive. Installation took probably a total of 5 minutes or less-the old cover came off effortlessly (it was half off anyway) and the identical new replacement simply snapped into place and..............wah-lah as they say-back in business. It was a pleasure to do business with this company-their staff is courteous and efficient-and oh, yes, the first shipment was indeed picked up by Fedex when they delivered the correct package and was credited back to my credit card as promised. Thank you for being there Partselect.
John Reid
Cape Coral Florida

Repair was tremendously easy. All I did was remove old light switch by prying out with screw driver and plugging in the new light switch and pushing it into the hole. Simple! The instructions weren't needed, but they were very thorough.

Open door. Remove broken bin. Replace with new bin.

Replace the follow items

Secondary Duel Water inlet valve Part no: WPW10341329
Control electric W10861900
Ice maker Fascia Heater Kit part PD00026897 W10619962
Ice Maker Assembly PS117392 replaced it two times
And now icemaker is not ejected ice
Roland Crenwelge
804-789-1795