Models > WRS586FLDB00 > Instructions

WRS586FLDB00 Whirlpool Refrigerator - Instructions

Jump to:

All Instructions for the WRS586FLDB00
91 - 105 of 218
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
David from ENGLEWOOD, FL
Parts Used:
WPW10430639
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Broke the bottom freezer door bin
The new bin slid right into the required slot
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Cathy from HOPATCONG, NJ
Parts Used:
W11384469
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Light rocker switch broke and refrigerator light couldn't go on.
I just popped out the old switch with a flat head screwdriver. Removed the connections and then installed new switch by reversing steps. Popped in back in and the light went on.
2 of 4 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
George from Port Orchard, WA
Parts Used:
EDR1RXD1
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Changed the filter
Took the old one out and put the new one in
3 of 7 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Carlton from CHICAGO, IL
Parts Used:
W11396033
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
Light out.
Popped out the old switch and replaced it with the one dying
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Richard from PORT JERVIS, NY
Parts Used:
W11396033
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
No problems
Just plugged it in
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Bettie J from RIVERDALE PK, MD
Parts Used:
WPW10260985
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Replacement
Great
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Garrett from RANDALLSTOWN, MD
Parts Used:
WPW10251076
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Pliers, Screw drivers
The ice maker assembly went bad.
I use a Screw drive a Nutdriver set Needlenose Pliers and it took 30mins to fix.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Chingnan from SUGAR LAND, TX
Parts Used:
WPW10225581
Difficulty Level:
Really Easy
Total Repair Time:
1- 2 hours
Tools:
Nutdriver, Pliers, Screw drivers
Freezer 4-15 F refrigerator 50 - 55 F
Just follow youtube examples. Work in freezer. Troubles was I didn't fix the problem. Experts say thermostat is the best one to replace (53%). Anyway they are not always right.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
John from DUNNELLON, FL
Parts Used:
WP2198628
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Pliers, Socket set
Ice maker grinder motor was not running.
Remove the ice bucket and check that the auger that turns in the ice bucket is free to turn. Cover the open freezer with cardboard or whatever to retain most of the freezer temperature. Remove the holder that supports the top of the motor shaft. Check the splines on the upper part of the motor shaft and also check the seal under the holder. Open the access the door to the motor, remove wiring connector and unbolt the motor. Check the lower splines on motor shaft for condition, clean the shaft and apply new grease to the splines. Before installing, connect the wiring to the new motor, push the door switch in, press the ice dispenser arm outside the door to make sure the motor runs. If all ok, check the motor shaft for fit in the new motor. Be careful not to install the motor shaft too deep in the motor splines, otherwise there may not be enough spline showing on the top end to engage the auger. Bolt the motor in place, close access door and install the holder and ice bucket and make sure everything works. If there is not enough spline showing thru the holder to engage the auger, take pliers and pull the shaft up a bit. This seems to be a hit or miss fit on the shaft but you can adjust the height of the shaft without taking every thing apart again. That's all, not difficult at all. But do check parts and pieces for anything else you might need, parts wise, before ordering the motor by itself like I did. Shipping is high, so try to order any associated parts needed when you order the motor. By the way, This site are great to work with!
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
allen from LANCASTER, CA
Parts Used:
WPW10225581
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver
leaking water in freezer
with vidio
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Kendra from Grandy, NC
Parts Used:
WPW10710203
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
The plastic door bin broke and fell off. There are 2 different sizes and I needed the larger bin.
The bin was very easy to install. Just make sure you are putting it back in the same spot as there is a small bin and a larger bin on the door and they need to go into the right place. The bin just pops back in easily no tools required. Was a perfect fit.
2 of 5 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Kathy from TEMECULA, CA
Parts Used:
W11384469
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers
Light switch broke off
We looked up the problem online with the model number of the refrigerator. We ordered the part and followed the video installation that was sent with the order and was found online prior to purchasing
1 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
David Barnes from ROSWELL, NM
Parts Used:
W11384469
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Rocker on switch broke off
Eased the putty knife under the edge of the switch housing and pried it off. Pulled two wires off the old terminals and hooked them onto the new one and reinstalled into the refrigerator body.
1 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
James from Shrewsbury, MA
Parts Used:
W11396033
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Broken light switch
Pried out the old switch and installed the new switch.
1 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Howard from Columbus, OH
Parts Used:
EDR1RXD1
Difficulty Level:
A Bit Difficult
Total Repair Time:
30 - 60 mins
Tools:
Wrench (Adjustable)
Time to replace water filter
Removed old filter then insert new filter and pushed door closed
2 of 5 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the WRS586FLDB00
91 - 105 of 218