2VED21ZKFN00 Whirlpool Refrigerator - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- edgar from PAWTUCKET, RI
- Parts Used:
- WPW10225581
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Nutdriver, Pliers, Screw drivers
refrigerator not freeze
i didn't repair replace capacitor, bi metal defrost thermostat and still not freeze also replace light door switch any suggestion thanks
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Albert from bonita springs, FL
- Parts Used:
- WP2182179, WPW10329686
- Difficulty Level:
- Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers, Socket set
Door jumped when opening and made noise "clunk"
Removed right hand door of side by side. Replaced both cams and put door back. All is well.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Ouida from LORMAN, MS
- Parts Used:
- W10508993
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
Tray missing
Simple fix. I watched the video it was great.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- CHARLES from INDIANAPOLIS, IN
- Parts Used:
- WP2196190
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
Replace two broken Door Shelf Retainer Bar End Caps
To get the broken end cap off of the retainer bar, hold the retainer bar still and pull the broken end cap straight off on a line that is parallel with the retainer bar, and with a little tugging. Might even have to tap the end cap lightly. Slide the new cap back on to the retainer bar and then put the end cap back into the door slot by putting the bottom of the end cap into the slot first by tilting the upper part back a little, then pushing down on the end cap to get it down into the slot far enough to let the upper part go in. Then adjust the end cap up slightly to cause it to snap into place.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- John from Miami, FL
- Parts Used:
- WP2188664
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
cracked meat pan
Very simply change old part just by hand
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Harry from McComb, MS
- Parts Used:
- 2186649W
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Handle broke
I removed the screws holding the handle pieces to the refrigerator, then put the new handle in place and screwed in the screws.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Max from Jonesboro, AR
- Parts Used:
- 4386774
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Socket set
Broken wheel on leveling roller
I removed one bolt and took out the old roller after first blocking up the fridge. Then I was puzzled for a moment because the hole in the new assembly was not tapped. But then I saw that the old bolt was a self tapping bolt. I used it to tap the hole then removed it and installed the new assembly. No sweat job.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- David from NORFOLK, VA
- Parts Used:
- WP2188664
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Vegetable / Meat pan broken
Took the old one out and put in new one in reverse order !! Replaced vegetables then slide pan in and shut refrigerator door !! EASY !!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- ROBERT from UNION CITY, IN
- Parts Used:
- W10508993
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Shelf broke due to overloading
Remove old shelf, install new one. Five minutes - tops; don't overload the new one.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Heather from LAGUNA NIGUEL, CA
- Parts Used:
- WP2188664
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
There is a catch on left side..
I don’t know if this is because of inner slider to adjust humidity but fits good enough. And the fridge is very old. Probably from 1980’s Slid new drawer in
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- William from ALBUQUERQUE, NM
- Parts Used:
- WPW10329686
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Nutdriver
Broken door stop.
Replaced very easy.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Lee from AMARILLO, TX
- Parts Used:
- WP2196100
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
end cAPS BROKEN from shelf
attach caps to each end of shelf and fixed to door
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- John from Albuquerque, NM
- Parts Used:
- WP2182179
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Socket set
Refrigerator door wouldn't close automatically
I removed the three small bolts (under cosmetic cap) located on the right top hand side of the refrigerator and pulled off the door. Replaced the top and bottom cams, put back on the door, screws and cap. Door works like new and the Wife loves it.
On a side note, don't be confused when ordering the top and bottom cam as they are both on the bottom of the door.
On a side note, don't be confused when ordering the top and bottom cam as they are both on the bottom of the door.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- John from ATHOL, ID
- Parts Used:
- WPW10329686
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Nutdriver
door would not close properly
removed screw on top cover emptied ref door remove 3 top screws holding bracket on top. lifted the door then remove old cam then reassembled.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Deborah from INDIANAPOLIS, IN
- Parts Used:
- WP2188661
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
Put in a drawer!
Didn't do anything.
Was this instruction helpful to you?
Thank you for voting!