6GX0FHDXXY0 Whirlpool Refrigerator - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Doris from Holden, MA
- Parts Used:
- W10827015
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Replace pantry lid
It was great! Took my husband less then 5 minutes to fix. Your delivery time is excellent. This is the second time I order from you and would do so again if the need arises. Thank you so much. Don't be afraid people go ahead and order.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Veronica from Hannibal, MO
- Parts Used:
- W10827015
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Broken lidNo instructions came with it
Took the shelf glass out, pulled drawer out, put lid on put shelf back together. Everything fit and works well.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Gail from Golden, CO
- Parts Used:
- W11384469
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Broke light switch while cleaning
use kitchen knife to pry out. replaced switch assemble and pressed back into place. Could not have done this with out help from previous customers. Thanks
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- HARRY from FSTRVL TRVOSE, PA
- Parts Used:
- W11396033
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Freezer drawer light switch failure.
Disconnect plug from wall. Insert putty knife between light switch.and trim panel , apply pressure to depress plastic spring holding switch in place. Apply a slight twist too putty knife releasing switch from trim piece. This wil expose plug connected to switch. Disconnect plug from switch. Connect new switch to plug. Insert switch into trim. Plug refrigerator into wall socket.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Thomas P from Centereach, NY
- Parts Used:
- WP12656105
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Nutdriver
crisper door hinge pin snapped off
had to remove shelving, crisper's, then unscrewed end cap. lifted it off set pin. and reversed for reinstallation. reefer door is reversed which makes it prone to close on crisper if not fully closed
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Gregory from Potomac, MD
- Parts Used:
- WP67002659
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
plastic rails broken
Remove crisper and take off white front piece from old crisper and add to new one. Replace in refrigerator.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Kevin from Ladson, SC
- Parts Used:
- W10827015
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Cracked Lid
No tools needed. Snapped right into place, easy as could be.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Peter from PLEASANT VLY, NY
- Parts Used:
- W10830162
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Door gasket dried out and falling apart
This is a simple repair, the gasket is pressed into a groove in the door and only needs to be eased out (pulled) by hand and the new gasket pressed back into place by hand. Starting the installation in one upper corner to make alignment easy. The side of the gasket with the table face center. For this model remember the doors are not symmetrical and the gaskets are a different size for each door. The gaskets come folded which puts a kink in the gasket. I set them out in the warm sun to straighten out before installing.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Doralyn from Grand Junction, CO
- Parts Used:
- WP12656105
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Nutdriver
Hinge on snack drawer broken
First remove the snack drawer, glass shelf above it and other plastic pieces which just sit in place. Remove the three 1/4" screws that hold the end cap to the refrigerator liner. Lift up on the endcap and then out as there is a blind slot it slides into. Tilt the endcap out from the back and remove it. Remove the drawer glide from the endcap and transfer it to the new part. Reinstall the endcap by engaging the two plastic ends into the rear corner of the cabinet and then sliding it down on over the blind support. Install the three 1/4" head screws to secure the endcap to the liner. Reinstall the glass shelf and pantry drawer.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- John from LEAWOOD, KS
- Parts Used:
- WP67002659
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
transfer white border on old drawer to new drawer
with screw driver, pry up white upper drawer border and cover carefully. Place over new drawer in same location on a hard surface. press the upper border over the new drawer and press downward.carefully until it snaps in place. insert drawer in old drawer location.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Lee from TAYLOR, AZ
- Parts Used:
- W11173556
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
Broken
Remove and replace
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Carlton from CHICAGO, IL
- Parts Used:
- W11396033
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Light out.
Popped out the old switch and replaced it with the one dying
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Craig from Minneapolis, MN
- Parts Used:
- WP67002659
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
broken
This has nothing to do with the repair - But with the customer service. I ordered and received a crisper in the mail and it had a crack in it. When I called the customer service # they helped me quickly and explained exactly how the credit/re-ship would happen. I received my new crisper in just a couple of days. Thank you!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- willie from LOUISBURG, NC
- Parts Used:
- W10830162
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
bad door gasket
pull out old gasket and pushed in new one
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Scott from Ortonville, MI
- Parts Used:
- WP12656018
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Nutdriver, Screw drivers
Broken hinge pin for the crisper.
Removed screws from the broken end cap and removed it. Installed the existing internal parts in the new end cap and reinstalled the screws. Very easy and the exploded diagrams on your site made it a very simple repair.
Was this instruction helpful to you?
Thank you for voting!