BRS70WRANA00 Whirlpool Refrigerator - Parts

This water inlet valve is for the ice maker and water dispenser in the refrigerator. To remove outlet tubing, depress ring that the tube slides into. Please remember to disconnect the power and water ...

This part may come with a plastic or metal auger depending on the factory. It will work with your appliance if found with the model number. (Make sure you install properly at back of ice container, be...

This screw is for refrigerators. Follow appropriate safety practices when installing screw

This kit no longer includes the connectors. It is only the tubing/water reservoir. Note: This tubing requires an adapter coupler (PS369735) to take the tubing from 1/4 inch to 5/16 inch.

This clip is sold individually.

This dispenser door pin comes with the washer.

This door gasket is used to seal the freezer door when closed.

Support wheel assembly with bracket. Kit of 2.

The heater is located at the bottom of the evaporator. The defrost heater heats the evaporator in the defrost mode of operation. The thermostat must be replaced when replacing the defrost heater.

This part strips ice from the icemaker mold during the ejection cycle to prevent ice pieces from falling back into the mold.

This screw is sold individually.

This kit comes with the compressor relay, overload and cover.