WRF555SDFZ Whirlpool Refrigerator - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Robert from Decatur, GA
- Parts Used:
- WPW10196393
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Food Freezing
Remove plastic vent cover. Just snaps out. Take out two screws that hold damper cover on. Unclip and unplug damper assembly. Snap in new assembly and plug in. Replace covers. I was pretty sure this would fix my problem after observing the damper for several days. It would stay open and when I moved it by hand it would open a little more and then close. Easy fix!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Alfred from Erie, PA
- Parts Used:
- WPW10196393
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
noisy
Popped the cover to expose the part. Then removed two screws and unplugged the part. Exchanged the new part for the old. Plugged the new part in and replaced the screws And the cover.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Cathy from San Pedro, CA
- Parts Used:
- EDR4RXD1
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Water filter needed to be changed
Piece of cake. Took out old filer and put in new one!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Dean from Santa Ana, CA
- Parts Used:
- W10830055
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
a little problem with freezer gashet not fitting at top of drawer used hot wash rag to smoth it out.
Removed old gasket from right side of refrigerator and the bottom freezer doors. Reinstalled both gaskets to doors anbout 15 minutes in all.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- William from Bronxville, NY
- Parts Used:
- EDR4RXD1
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
water was slowing down
Unscrewed the old filter and screwed in the new one
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Alice from Ocala, FL
- Parts Used:
- EDR4RXD1
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Needed to install new window a/c unit
Placed in window and pulled out sliders.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Valentin from CLOVIS, CA
- Parts Used:
- W10882923
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Nutdriver, Screw drivers
The ice maker stop making ice.
I looked on YouTube few videos how to replace the ice maker.Then according videos I replaced the ice maker.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Richard A. from Boones Mill, VA
- Parts Used:
- WPW10196393
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Milk was freezing in Refig section, 28 F temp
Noted the Damper Assemby in the upper rear of refrig section,was always staying open during checks for problems. Controls appeared to be controlling temp changes when adjusted. Pulled the damper assemby after removing two screws holding the diffuser/cover(diffuser pops off with screwdriver) Damper assembly snaps out , unplug wires, snap new damper assembly in place, reconnect wires at the plug, replace cover with foam insulation, secure with screws replace diffuser snaping in place. Recheck settings for desired temperatures.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- David from Portland, OR
- Parts Used:
- EDR4RXD1
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 15 - 30 mins
Replaced ice & Water filter, but message on refigerator still shows "Replace Filter"
As per instructions to replace filter
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Milay from Miami, FL
- Parts Used:
- W10882923
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Nutdriver, Screw drivers
Ice Maker stopped working a second time
The customer service was great and I received my part the next day which was awesome. I was a bit surprised that inside the box no instructions came for the installation. It was a bit difficult without the instructions. After an hour we installed the ice maker and it stated working. The one thing I like the most is the one year guarantee. That gives me peace of mind.
Was this instruction helpful to you?
Thank you for voting!