RF267ACWPXAA Samsung Refrigerator - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Libor from Danbury, CT
- Parts Used:
- DA81-01345B
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Pliers
door spring
replacing broken french door spring.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Kathy from BUTTE, MT
- Parts Used:
- DA81-01345B
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Door
Replaced the spring on my French door refrigerator
Was super easy
Was super easy
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Bill from RALEIGH, NC
- Parts Used:
- DA32-00006R
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers
Refrigerator was too cold - down to 18 degrees Fahrenheit.
Removed shelves. Removed back cover. Removed old sensor. Installed new sensor. Replaced back cover. Replaced shelves. Works fine.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Sharol from Culdesac, ID
- Parts Used:
- DA81-01345B
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Brokjen spring
Lifted out the broken part and replaced with new spring.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- RYAN from RIVERBANK, CA
- Parts Used:
- DA81-01345B
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Pliers
french spring broke
after receiving spring installed spring in seconds. Thanks partselect.com Ryan Cappell
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Andrew from Bensalem, PA
- Parts Used:
- DA81-01345B
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
French spring broke.
pushed new spring in.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Gregory from North Richland Hills, TX
- Parts Used:
- DA97-05422A
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Not making ice. Making ice slowly. Clicking sound when making ice.
(1) Set ice production to OFF from the front panel of the refridgerator. (2) Inside the fridge, remove the screw holding the panel covering the cable for the ice naker assembly. (3) Remove the panel. (4) Disconnect the power cable of ice maker. (5) Holding the assembly with one hand, release the locking clip of assembly housing, and slide assembly forward until it is free. (6) Remove the ice maker assembly. (7) Install the new assembly by reversing the previous steps. (8) Reset the ice maker by pressing the reset button and holding it for at least 8 seconds. The first time the ice maker is primed with water, there are 2 chimes. (1 High , 1 Low).
Was this instruction helpful to you?
Thank you for voting!