RF268ABRS Samsung Refrigerator - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- JOHN from ARLINGTON, MA
- Parts Used:
- DA97-07276E
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
french door mullion busted
Piece of pie! Took of the screw caps, the screws, disconnected the wire switch and reversed direction with the new one. 10 minutes tops.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Bill from RALEIGH, NC
- Parts Used:
- DA32-00006R
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers
Refrigerator was too cold - down to 18 degrees Fahrenheit.
Removed shelves. Removed back cover. Removed old sensor. Installed new sensor. Replaced back cover. Replaced shelves. Works fine.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- RYAN from RIVERBANK, CA
- Parts Used:
- DA81-01345B
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Pliers
french spring broke
after receiving spring installed spring in seconds. Thanks partselect.com Ryan Cappell
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Sharol from Culdesac, ID
- Parts Used:
- DA81-01345B
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Brokjen spring
Lifted out the broken part and replaced with new spring.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Sara from BAKERS MILLS, NY
- Parts Used:
- DA61-03734A
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
We misplaced the mounting screws for our handles while moving.
It was easy! I just used an alan wrench to losen the side bolt, then slid the handle into the new mounting screws that I had hand-screwed and then tightened it all up.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Timothy from SALISBURY, NC
- Parts Used:
- DA63-02284B
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
Ice tray had cracked and broken. The water is still not filling up my ice tray.
The replacement was fairly simple. I removed the existing tray and detached the water line. Once the water line water reattached to the new tray I inserted into the ice maker.
*** The problem I'm having now is the water is not filling up the tray***
Not sure what I did wrong? Any help would be greatly appreciated!!!
*** The problem I'm having now is the water is not filling up the tray***
Not sure what I did wrong? Any help would be greatly appreciated!!!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Andrew from Bensalem, PA
- Parts Used:
- DA81-01345B
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
French spring broke.
pushed new spring in.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Jerry from Manvel, TX
- Parts Used:
- DA61-03763A, DA61-03762A
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
brackets broke that hold the tiltable tray for the freezer
Extremely simple, remove the old tray brackets and snap the news one in place. Put just enough pressure till you here them click in place.
Was this instruction helpful to you?
Thank you for voting!