RS25AQXGW00 Roper Refrigerator - Parts

This dispenser door pin comes with the washer.

This kit includes the Relay, Overload and cover. The start relay briefly boosts the compressor, and then shuts off as soon as the motor gets up to speed and the Overload provides added protection f...

Support wheel assembly with bracket. Kit of 2.

This part strips ice from the icemaker mold during the ejection cycle to prevent ice pieces from falling back into the mold.

The heater is located at the bottom of the evaporator. The defrost heater heats the evaporator in the defrost mode of operation. The thermostat must be replaced when replacing the defrost heater.

This door gasket is used to seal the refrigerator door when closed to keep the cool air inside and the room air out.

This kit comes with the compressor relay, overload and cover.

16ml

This is a decorative front cover that is made of plastic that covers the opening to where the icemaker is located and disables contact by the user while the icemaker is engaged.

Once a glass is pressed against the actuator pad it will cause the dispenser to deliver water when activated.

This motor rotates the auger. When the auger rotates, it pushes ice out of the bin, through a chute to the user.

This white icemaker assembly washer is less than an inch long.