MTX14CYSDRAD RCA Refrigerator - Instructions

Not really a repair, just replaced the vegetable drawer tray, I just set the part in and it fit perfectly.

Just as your video described, although due to the age of the fridge, it took a bit longer to remove the defective switch. Your video made this so simple, I can't imagine why we lived with a dark fridge for so long! I was ready to buy a whole new fridge, as repairmen are often nonexistent for small repairs. I am the biggest fan of your company & it's repair video. THANK YOU SO MUCH

My wife and I followed the installation video & put the gasket in hot water. We struggled to get it started in the second corner on top. Gasket had cooled down so wasn't wanting to go in the slot. I finally got the bright idea to use a hair dryer to warm the gasket as we pushed it along.
That helped us finish the installation.
Not sure the new gasket is the complete answer to the leakage at the top of the door (forming ice crystals). The MAGNETS ARE WEAK compared to my 1 year old GE top freezer refrigerator!
My newer refrigerator "snaps" shut.

We thought we would have to replace our frig, but found the part online and it fit perfectly. It's slightly different than the original because it is stronger. All we did was remove the items from the tray, unsnap the broken one and slide the new one into place.

Using plyers Pulled old switch down and out. Put new one in and pushed new switch up into position. The switch plugs into the contacts, no wiring needed. Worked like a charm. You saved me 200 dollars GE repair bill. Thanks

after simply replacing shelf, I used the enclosed plactic washers to raise the height of door, so it would clear new shelf. It all worked as planned, thanks

Removed Ice shelf,
Remove rectangle cover by removing the two screws and lifting straight up.
Pulled fan off slowly.
Removed two hex screws holding motor bracket.
Remove cover.
Remove two hex screws holding remaining bracket from fridge.
Pull wire off motor noting where they were plugged in.
Pull apart brackets holding motor and remove motor noting how the motor and brackets fit together.
Reverse to install.

We removed the old Drawer Cover and replaced it with the new one. The Refrigerator Door had trouble closing. So we inserted the 2 plastic washers as described in the directions enclosed in the packaging. It was pretty straight forward and an easy fix. Thank you Hot Point and Part Select. Pete and Bonnie, Brooklyn NY

per your instructions

Just snapped in.

Fairly easy I pull the fridge foward and remove the backing board and notice the fan wasn't working, so I remove the fan and bench tested and it was burned then I clean the condenser with compress air if you don't have air then a vacuum cleaner works then once the part arrived I install it the now if working very good

Emptied freezes, turned off power, took floor of freezer out [4 screws ], took two screws out of fan mounts and replaces fan. Reassembled by reverse process. Simple

We received the part. Pulled out the old tray and put in the new one. It fit perfectly and looks great. It took no time at all!!!!! Thank you for the prompt service too.

all I had to do is remove the broken cover then replace the new one which only took about 2 minutes. It was so easy and it is a little more durable than the original one.

Removed the old pan cover, which lifts out very easily, and replaced with the new one. I had to install the two plastic washers, that came with the kit, at the bottom of the refrigerator door around the hinge pin. To avoid having to take the door off to install the washers, I cut a piece out of each washer big enough to fit onto the hinge pin. I first lifted the door up and placed a support underneath and then I snapped the washers onto the pin. This was done so the door would close properly. Installation instructions were enclosed with the shippment. Installation was less than 15 mins.