1867 (AWBCNA4) LG Refrigerator - Instructions

I popped the old switch out of place and then disconnected the wire harness from the switch with a pair of needle nose pliers. I then inserted the harness into the new switch and popped the switch into place. Super easy and fast.

The repair went well. They actually had to replace the motor. This saved me a lot of money having it repaired in this manner. Very professional & pleasant.

Uncoupled the old connector, replaced with new connector and attached supply line. Repair easy with right part, prior to ordering the right part I had tried a compression fitting and it still leaked. U-tube and others demonstrating repair assured me I was on the right path.

unfortunately my fridge stopped working. I purchased another but wanted to try and repair the old one. when ew one arrived, the old one was supposed to be put in garage but instead was hauled away. Had delivery return next day but they had as already removed and lost the handle screw for the bottom freezer and the screw that holds handle in place. ordered the handle screw and picked up the nut. very simple to install the screw and put handle back on.

I called LG and followed the instructions given over the phone. The instructions couldn't have been simpler. Disconnect the appliance for several hours and then connect again. I disconnected the appliance overnight, cleaned out the freezer, and reconnected it. Problem solved. Did not need to call a repairman and did not use the clips.

Removed the old basket and replaced it with the new one. Easy as pie.

Door holder, really simple, remove two phillips head screws, throw awy old holder, replace with new, reinstall two screws. Door basket, slide out old basket, replace with new. Prices were more than fair, delivery very prompt. Will use again.

Removed 4 Stainless steel screw holding mounting assembly containing ice maker and motor. Unplug large plug from refrigerator inside wall and removed assembly. Closed refrigerator and lay asembly on flat surface. Removed ice maker plug from wire harness. Unscrewed ice maker mounting screws from mounting assembly. Reversed process to install new icemaker. Be sure to turn ice maker plug assembly to fit in holder on back of assembly and tape back in mounting assembly so assembly wil go all the way back in the door without forcing. If done properly, the ice bucket will slide in easily and the door to ice maker compartment will close easily without any problems.

Simply used a flat head screwdriver to get the first few inches of the gasket out of its track and after that just pulled it by hand. New gasket slipped over the door, lined up the corner and pressed into in the track. Checked to see that it was snug all over and we were done. 5 minutes at the very most. Never would have noticed this. Took all the bins out of the freezer to give it a good cleaning and noticed the torn piece hanging. Our refrigerator runs much less often. Expect to see a difference in our electric bill!