Models > GC-L288GSXM > Instructions

GC-L288GSXM LG Refrigerator - Instructions

Jump to:

All Instructions for the GC-L288GSXM
16 - 30 of 48
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
BG from WEATHERFORD, TX
Parts Used:
MHY62044106
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers
I actually took a picture of the correct spring installation at a big box store that carried LG. I had called LG, but they said they didn't have any installation brochures, and to call a registered LG repairman. That was out of the question, since the repairman would charge $100 just to show up.
I looked at the picture I took. Used needle nose pliers and inserted one end. Unless the lady of the house is very strong, this should be handled by a man, because of the rigid spring. Once the spring was inserted into one side of the flap, I used the pliers to get the other end into the proper slot. Very easy, but the spring is very strong !!
2 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Kevin from DADE CITY, FL
Parts Used:
MHY62044106
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
Left French Door would not close properly
Removed two screws from door and three locking brackets with a small common screw driver. Raised the bracket, slide in the spring, held down the bracket, installed screws and plastic covers. Less than 2 minutes. Easy application no problem with the new spring or ,mullion..
2 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Jeffrey from RICHMOND, TX
Parts Used:
ADX73550621, ADX73550624
Difficulty Level:
Very Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
Door gaskets on French doors needed replacement.
Saved me $175.00 to $250.00 for an appliance repairman to come to my house for this. Absolutely simple to do. Pull gasket from right side door, no tabs or screws. Replace with new gasket, simply push new in by hand. Left side door needs two screws removed from’ flap. Now, gently bump the bottom of the flap to lift the flap up only three inches or so. Remove the electrical connection tab under the metal plate that the two screws secured. Now, repeat what you did on the right side door. Simple!
2 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Frank from GREENSBURG, PA
Parts Used:
AAP73631502
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Broken door shelf
Replaced shelf. Original shelf was the wrong size
2 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Dave from CORDOVA, TN
Parts Used:
AAP73631702
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Old assembly had broken clear plastic.
Simply lifted old part up, removed. Took new part put in place and pushed downward as it firmly locked in place. Less than 1 min.
2 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Michael from SALINAS, CA
Parts Used:
ADX73550624
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
Door gasket tore.
With a small flat blade screw driver, gently pry the corner of the gasket from the door.
Pull it loose across the top, then down the sides.
Wipe the gasket track clean with a damp cloth.
Start installing the new gasket at one of the top corners. Then the other top corner. Press the gasket into the track between the top corners.
Next do the bottom corners. Pressing the bottom between the corners.
Then press in each side.
Elapsed time: 3-5 minutes.
2 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
MIKE from MENASHA, WI
Parts Used:
ADX73550624
Difficulty Level:
Very Easy
Total Repair Time:
15 - 30 mins
Tools:
Pliers
After 10 years of service the right door gasket needed replacement.
It was SO easy. No clamps or brackets. Grabbed the gasket with pliers to get started removing it - just pull it out of the deep groove inset around the perimeter of the door. Within one minute I had the old gasket removed. Started installing the new gasket by inserting the top right corner 1st (pushing the new gasket profile into the deep groove inset on the door). Working around the top and right side slowly inserting the gasket profile into the deep groove around the entire door. You may have to "adjust" a bit by pulling on the gasket but within 5 minutes I had the new gasket in-place never having to turn off the refrigerator. YouTube has great "how-to" videos. It's easy!
2 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
MJ from LAGUNA HILLS, CA
Parts Used:
AAP73631702
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Broken left sided attachment clasp/arm
The replacement basket for the left swing door went extremely smooth. The part was an exact fit and just required a little pressure while attaching the new replacement part.
highly recommend part select in doing a replacement for this part.
The schematic for the refrigerator is blurry and difficult to see on-line, so one a representative from parts select assisted me in finding the correct part.
two thumbs up!
2 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Tom from BLUFFTON, SC
Parts Used:
ADX73550624
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Torn door gasket
Pulled old gasket off by hand. New gasket was easy to install by pushing it into molded cutout in refrigerator door.
Very satisfying to have no glitches in the seamless installation.
2 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Jodi from WINTER GARDEN, FL
Parts Used:
AEQ73110210
Difficulty Level:
Very Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
My ice maker wouldn't release the ice, nothing was frozen and the motor would just bind
I bought the ice assembly motor only, super easy to install, remove the three main screws, lift out assembly, detach the cable. Then remove the screws on the parts, lift the tape, redo everything in reverse and it works flawlessly!
2 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Katherine from NEW PRT RCHY, FL
Parts Used:
MHL62691504
Difficulty Level:
Very Difficult
Total Repair Time:
More than 2 hours
Broken shelf for the vegatable bins
The glass was ordered correctly. The part was too big for mt refrigerator. I tried to send it back, but I got no reply. I tried cutting the glass to size and it shattered. I wasted 60.00 and im disgusted with your company.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Johnny from MOUNT OLIVE, AL
Parts Used:
AJU72992601
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers
Leaking
Swapped old one with new one. New one had extra plug not needed.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Angela from SAINT JOSEPH, MO
Parts Used:
AEQ73110210
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
Ice tray was not rotating any longer
Took the old one out and put the new one in.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Ralph from ROSWELL, NM
Parts Used:
AJP73594506
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Broken wheels on drawer
Replaced drawer.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Delores from WINNIE, TX
Parts Used:
MHY62044106
Difficulty Level:
Very Difficult
Total Repair Time:
1- 2 hours
Tools:
Pliers
This is the second time they have mailed me the wrong spring. I talked to someone the last time and explained everything About my refrigerator. I had a Repair man come and try to put this part on my refrigerator this time and he told me that this spring is not for this side of my door. The first tim
Expensive to have repair man come out and find out that I’ve been mailed wrong spring again. My icemaker is on the left hand side this is the side of refrigerator- I need the spring for left side with the ice maker. Twice they have mailed me the Wrong spring that goes on the right hand side I have tried to explain this to the person that waits on me. Do I have to pay for another spring and mail this one back ?i have mailed one back and postage is getting expensive.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the GC-L288GSXM
16 - 30 of 48