Models > KRFC302ESS07 > Instructions

KRFC302ESS07 KitchenAid Refrigerator - Instructions

Jump to:

All Instructions for the KRFC302ESS07
106 - 120 of 208
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
Elizabeth from Greencastle, IN
Parts Used:
EDR4RXD1
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
It was time to change the filter for the first time
Opened up the door that covered the filter, unscrewed it and put the new one in and closed the door back up.
2 of 6 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Myrna from Port Carbon, PA
Parts Used:
EDR4RXD1
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
ice maker not working
replaced ice and water filter
2 of 6 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Rodney B. from Crestview, FL
Parts Used:
W11395888
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Filter stopped up. Causing the refrigerator to make a loud noise. water dispenser didn't work. less than 4.00 fixed all that
Shut off water supply. filter is located in the upper right hand corner of the refrigerator on the inside. open the drop-down door. by hand pull the filter downward. then twist it to the left one quarter turn. it should pull out. I replaced it with a filter bypass plug. you can purchase a high quality filter to replace.it don't buy cheap filter.I made that mistake! hope this helps good luck!
1 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Harold from Lindenhurst, IL
Parts Used:
W11396033
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Pliers, Screw drivers
icemaker
installed new parts
1 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Keith from Racine, WI
Parts Used:
W11396033
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Light switch broken
I used a knife blade to slip under the edge of old switch to pray it out of the hole it was inserted into, switched the wires and replaced the new switch into the same hole. It took about five minutes!
0 of 1 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
WES from SPRINGVILLE, AL
Parts Used:
W11396033
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Switch Controlling Light When Door Open Was Briken
Poped ou the old switch, connected new switch and pushed back into socket.
0 of 1 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Richard from Smyrna, GA
Parts Used:
W11396033
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Frost in bottom freezer, freezer 8%, ice maker works
replaced electric control board, defrost for six hours. next day (24 hours) same problem, [email protected]
0 of 1 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Matthew from Buffalo, NY
Parts Used:
W11396033
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Pliers, Screw drivers
Broke plastic tab on auto light switch
Used screw driver to pop out old switch. Used pliers to hold wire connection from fall back into slot on fridge. Inserted new swith into plug and pressed new switch back in place.
1 of 5 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Charles from Newaygo, MI
Parts Used:
EDR4RXD1
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
no problem
took old one out installed new turn left out turn right in
0 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Marlene from Baltimore, MD
Parts Used:
EDR4RXD1
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Indicator light showed Water Filter needed to be replace
Dropped down the housing for the water filter, twisted, removed item and slotted in the new filter. Easy as pie.
1 of 5 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Robert from Davis, CA
Parts Used:
W11396033
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
Light Switch Was Faulty--Failed A Few Months After Purchase Of The Refrigerator
I had several times tried to get the old switch out but with no success. Ordered the "repair kit" and followed directions for removing old switch (there is a plastic spring clip on one side). Easy to unplug the old switch, plug the leads into the new one, snap the new one into place. Took about 5 minutes total--piece of cake. I wish I'd thought to try this years ago when the old switch began to fail.
27 of 629 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
dan from Westlake, OH
Parts Used:
WPW10122078
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
the tab that mounts the self opening lid to the pull out drawer broke off
After months of glueing and re-glueing the piece back together, I searched online using the product numbers on the back of the part. I found this website instantly and the replacement part. When I ordered the part I was concerned that it would not fit but it fit perfectly and the repair cost $20. I had a great experience with this site and will use it again.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Margaret from Minneapolis, MN
Parts Used:
WPW10534155
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Original refrigerator kick plate snap on connector broke and no longer able to keep kck plate in place
Pushed it on.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Louis from Covington, KY
Parts Used:
EDR4RXD1
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Ice and Water Filter needed to be replaced.
I snapped the cover plate to the filter open. Pulled the filter down and twisted counter clock wise to take filter out. I installed the new filter in by inserting the filter and tuning clock wise to secure the filter. I flushed the water for about two minutes and then allowed it to be put back into service.
Was this instruction helpful to you?
Thank you for voting!
Customer:
james from kansas city, MO
Parts Used:
EDR4RXD1
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
replaced water filter
followed instructions on box
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the KRFC302ESS07
106 - 120 of 208