Models > KRFF302ESS06 > Instructions

KRFF302ESS06 KitchenAid Refrigerator - Instructions

Jump to:

All Instructions for the KRFF302ESS06
1 - 15 of 302
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
Douglas from Byron, NY
Parts Used:
EDR4RXD1
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
light on to order water filter
Pressed in the end of the filter cover, lowered it down part way. Twisted the old filter 1/4 turn and removed it. Set in the sink to drain. Inserted new filter and twisted it to lock. closed cover. Done. Total time @ 1 Minute.
896 of 1008 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Ruth from Roxbury, MA
Parts Used:
WPW10671238
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Cracked & Snapped Center Crisper Rail
A very easy fix took all of five minutes
226 of 245 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Jake from Novato, CA
Parts Used:
EDR4RXD1
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Removing the existing filter by rotating as directed and then dislodging from 'docking' station proved difficult. Turns out, the old filter is under a bit of vacuum pressure and getting the unit to separate or release was a challenge.
I removed the drop-down outer housing by gently prying the sides of the two pivot pins at the rear. This gave me move 'room' to grip and slightly rotate then pull the old filter forward and away from the tight suction connection. I was concerned that I would be too forceful for the plastic assemblies and would break something; deliberate motions and a steady thought process on the problem helped disengage the darned old filter!
212 of 323 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Marilyn from Lilburn, GA
Parts Used:
EDR4RXD1
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Needed to change water filter in refrigerator
The switch-out of the water filter was simple with good instructions on the box.
The part was delivered very, very quickly!
160 of 248 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Kathryn from Cedar Springs, MI
Parts Used:
EDR4RXD1
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
water filter needed replacing
I unscrewed the old one and replaced it with the new one. The real benefit was I got the exact part I needed w/o a 30 minute drive and sales people that ignored me. I had gone to the local store the day before and come home with the wrong part because i could not get assistance and the part # I had did not match what was labled on the package. I used the same part # on the website and got exactly what was needed, less that 48 hrs after I ordered it. thanks for the prompt service. we will be a repeat customer
111 of 123 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Jack from DINUBA, CA
Parts Used:
W10619951
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Screw drivers
Water leaking from bottom of refrigerator onto floor
The video on website is very good and explains everything in detail. Just follow the directions. This is EASY!!!!
102 of 111 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
alvin from irmo, SC
Parts Used:
EDR4RXD1
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
easy and quick
unscrewed to removed old and screwed in new
87 of 163 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Kevin from Beckley, WV
Parts Used:
W11396033
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
while closing the door, the light switch fouled, resulting in the switch breaking
I used a flat screwdriver and released the lock tab on the bottom of the light switch, and pried the switch out, being careful to not damage the plastic around the mounting place of the switch, unplugged wiring from old switch, plugged in the new one and pushed the new switch into place. Job finished light switch now working.
59 of 90 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
albert from quakertown, PA
Parts Used:
WPW10671238
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
crisper drawers were off center rail due to c.r fracture
removed old rail,lifted glass panel above and inserted new rail-voila!!done.
42 of 46 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Fred from Oceanport, NJ
Parts Used:
W11291138
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers
Door switch module wore out
Pull out old module...
Remove 2 wires...
Tape to inside wall [don't want them to fall down into side panel]..

Order new switch..

Fed Ex pkg came on 2nd day..

Install wires on switch...
Press into opening...
Check door light on..[OK]
.. Done
40 of 55 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
James from Longmont, CO
Parts Used:
WPW10594329
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
Annoying sound from the fan control motor
Removed the grill and control cover in the top middle of the main compartment, removed the control, unplugged it and put in the new one. The thing that took the longest was figuring out that this was the part that needed replacing. The fridge is less than two years old and about 6 months ago the control started making these odd noises. Now it's quiet. Ah peace!
36 of 45 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Ken from St. Geogre Island, FL
Parts Used:
WP12568001
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Latch was broken on the filter cover and would not hold the filter in place.
Ordered a new filter cover, received in 2 days and installed it in about 5 minutes. Worked perfectly.
34 of 49 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Leo from Salem, SC
Parts Used:
WP2300868
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Had to replace a hose connector at the base of my refrig/frreezer
Perhaps a helpful hint:

When aI received the hose adapter/connector, I inserted the 2 hose ends only to have water drip from the connection.
I used a utility knife to remove an inch from each side, then reinserted the hoses. That made the differnce. Dry as a bone.

LG
43 of 76 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Michael from Bedford, NH
Parts Used:
WP67001716
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Ladder Hook had broken
This was a very easy repair job! I just needed to remove the drawers and shelving, put the new ladder hook on, and repace the shelving and drawers. It took longer to remove the items from the fridge, then it did to replace the ladder hook.
26 of 26 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Joel from DELRAY BEACH, FL
Parts Used:
W10830162
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Door gasket wasnt sealing anymore and had some minor cracks
First, I removed the old door gasket by pulling it out of the channel it was mounted in, noting the orientation of the gasket. Then, it was a simple matter of lining the new gasket up with the channel and pressing it into the groove. Very easy repair, and the door seals great!
26 of 26 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the KRFF302ESS06
1 - 15 of 302