1068480131 Kenmore Refrigerator - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Eric from Fort Myers, FL
- Parts Used:
- WP2198202
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Nutdriver, Pliers, Screw drivers
Feezer did not start well any more
Easy job due to great instruction video by PartSelect.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Adam from Randolph, ME
- Parts Used:
- WPW10662129
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Pliers
Frig not cooling.
After plugging in the new relay to no avail. I replaced the thermostat. That fixed the problem.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Robert from Casselberry, FL
- Parts Used:
- WP2198202
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Pliers, Screw drivers
Thermostat was bad,making compressor turn off. You had to tap under the area where thermostat was located to get it to turn on.
the repair from the video was exact to a tee. Very helpful 100%.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- John from Iselin, NJ
- Parts Used:
- 482469
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Nutdriver, Screw drivers
evaporator fan, noisy
Remove freezer shelves, panel, and change fan.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Mike from Mesquite, TX
- Parts Used:
- 4388538
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Pliers
video made installation a breeze
the online video on how to change out the part saved me tons of time and do it right.....keep those videos coming, also right part too and easy to find on your site
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- George from DeKalb, MS
- Parts Used:
- 4388538
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
The two front shelf support studs broke off.
I followed the instructions that came with the part. Less than five minutes it was good as new.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Thomas from Athens, GA
- Parts Used:
- 4388538
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Pliers
Shelf Support Stud Replacement
The shelf support the refrigerator crisper container end had broken off. I found the part on the website and viewed the installation video. If I had not seen the video I would have had difficulty completing the job. Following the video instruction the old bracket that supports the shelft broke off. But, because I had been covered in the video how to remove the bracket enabled me to overcome the part breaking. Good set of instructions made the job go well even with the bracket breaking.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Thomas from Weslaco, TX
- Parts Used:
- WP548049
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Burnt out bulb
changed bulb
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Margo from Baraboo, WI
- Parts Used:
- W11581579
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Broken shelf support in freezer
Removed correct part from those provided and slipped it into position. No tools necessary.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- VERONICA from SAN LEANDRO, CA
- Parts Used:
- WP2163438
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
needed a replacement part
Great experience, part was perfect, service was excellent.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- sarah from dearborn, MI
- Parts Used:
- WPW10662129
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Nutdriver, Pliers
Compressor having hard time kicking on
I simply watched the repair video and did it! Super easy, needed start device and capacitor. As easy as unplugging the old and adding the new. The video helped and gave me confidence. Wives can fix fridges too! Saved me $2500. Looks like I'll need a new excuse if I want a new fridge.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- martin from grafton, WI
- Parts Used:
- WP2149705
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Socket set
non functioning light switch in fridge
This repair was super easy. there are only 5 screws to remove to get at the defective switch. 3 in the housing where the light bulbs are and 2 in the front trim piece where the cooling adjustment dials are. I never did unplug the fridge ,but probably should have although nothing bad happened. I removed all 5 screws using a 1/4" socket ( a nutdriver would work well also). there is also a small dia rod that comes down from the coolness adj. wheel that when you re-assemble goes though the middle of the wheel. The switch has only 2 wires that clip on with the push on flat type connectors. Very simple. I removed the wires and then the switch can be removed( it is only held in by 2 squeezable side clips). I put the new switch in and connected the wires , checked to see that the lights went on and off. which they did. then just put the screws back in.....done. also I would like to say that when I ordered my switch it came super fast. I ordered it online at 11:00am on a tuesday and it was on my doorstep in wisconsin by 10:00 am the next day...Thanks
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- bradley from harlingen, TX
- Parts Used:
- WP2262181
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Nutdriver
stopped cooling
I looked for the obvious sign of malfunction, a leak lack of air flow dirty coil finding nothing obvious I checked the electrical components and the first was the start relay with a bimetal temperature switch was the problem that was identifyed when removed due to the relay sounding like it was internally damaged because of severe rateling
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Katina from Cambridge, MA
- Parts Used:
- WP2262181
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
The fridge was blowing how air in the freezer and in the bottom of the fridge.
I was careful to unplug each cord one at a time so that I can easily match them up to the new start relay. Once I got the cords plugged into the new start relay, I went ahead and plugged in the fridge and it worked like it never stopped working. I must admit, I'm still nervous about this fridge because I never had to do anything like this in my life so in the back of my mind, I'm always wondering if I did it correctly or not. I was giving a lesson on how to make sure that I have it on correctly but that didn't put me at ease..lol. Parts Select sent this part in less then a day and that made me appreciate there business even more. I was concerned that the part wouldn't get here until later on that week.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- ROBERT from WASHINGTON, MO
- Parts Used:
- W11581579
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Pliers
I,Lost Bracket
Replaced bracket-amazed to find how quickly I was able to id the part on this 20 year old refrigerator. Ordered the part and received it the next day! Thanks for the good service! , Bob
Was this instruction helpful to you?
Thank you for voting!