10654596400 Kenmore Refrigerator - Parts

This part is the top hinge for your refrigerator door. It is made of metal and is approximately 5 inches by 3 ¼ inches in size. This hinge is for the right side of the refrigerator door only. The left...

This OEM hinge kit includes the lower left and right hinges for both the refrigerator and freezer doors. It helps the doors open and close smoothly, stay aligned, and seal properly. Compatible with ma...

This kit no longer includes the connectors. It is only the tubing/water reservoir. Note: This tubing requires an adapter coupler (PS369735) to take the tubing from 1/4 inch to 5/16 inch.

This clip is sold individually.

This dispenser door pin comes with the washer.

This door gasket is used to seal the freezer door when closed.

Support wheel assembly with bracket. Kit of 2.

The heater is located at the bottom of the evaporator. The defrost heater heats the evaporator in the defrost mode of operation. The thermostat must be replaced when replacing the defrost heater.

This door gasket is used to seal the refrigerator door when closed to keep the cool air inside and the room air out.

This part strips ice from the icemaker mold during the ejection cycle to prevent ice pieces from falling back into the mold.

This is a decorative front cover that is made of plastic that covers the opening to where the icemaker is located and disables contact by the user while the icemaker is engaged.

Once a glass is pressed against the actuator pad it will cause the dispenser to deliver water when activated.