61004754 Kenmore Refrigerator - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Eileen from Prattville, AL
- Parts Used:
- 12001991
- Difficulty Level:
- Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Pliers, Screw drivers
ice door flap had broken off
followed repair insructions. used all parts sent. slight issue getting spring on correctly but once we did we were done!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Sharon from Sugar Grove, IL
- Parts Used:
- 61003804
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers
Water Dispenser didn't shut off immediately when glass was no longer pressed against actuator pad
We followed the directions in the video on the Parts Select website.My husband thought it was so easy and he isn't handy. I agree.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- George from Minden, NV
- Parts Used:
- 61005626
- Difficulty Level:
- Difficult
- Total Repair Time:
- More than 2 hours
- Tools:
- Wrench set
ice maker inopeative
went on line and ordered new ice maker for this model refrigerator. Received the new part. New icemaker provided video for replacement of ice maker.Used the video showing the removal and replacement of the ice maker to begin the removal process. (must remove one mounting screw, then raise the icemaker up then out to unlatch the fixture.) This took over one hour, then had to remove wiring arness. Instrucions indicated to "squeez" the locking clip holding the connector, it is impossible to see the connector so it was a "feel" process. It turned out that squeesing the connector from the sides, did not work, finally squeezing the locking clip (top to bottom) finally released the connector. Then the installation (per video) reversed the removal procedure and that turned out to be about a two hour task because to align the ice maker when you cannot see the alignment / holding brackets was a very difficullt task. Then when it was finally installed, the one mounting screw, would not align with the previous mounting hole, because the tab on the new one was longer, requiring drilling a new hole to hold the icemaker in place. The hole had to be made using the same (self-tapping) screw, since the space available when the icemaker is installed is very limited. After the mounting hole was partally made, driving the screw the rest of the way had to be done with a ratchet, other then that, everything was just great.
Was this instruction helpful to you?
Thank you for voting!