25344723100 Kenmore Refrigerator - Instructions

Two of my refrigerator door bins were broken and I had been using duct tape to hold them in place. I decided to look them up on PartSelect and was able to find exactly what I needed at a great cost. I ordered them and they came right away. I put them on the door needing no tooks and bingo, just like new! Imagine my heartache when one somehow broke. Well I contacted PartSelect and they sent me another one at no charge and in less than a week!!!

I aligned the right and left clips on the shelf with the tabs on the door and snapped the shelf in place.

It snapped right in place, less than 1 minute. Made he fridge much more uefull and way cheaper than buying a new fridge. I am gald that there are places that sell parts like this. THANKS. Also, shipping was extremely fast.

placed bin into the protruding plastic inplacement
and then just snapped it in its place.

Notice ice build up on the panel in front of the evaporator coil. Unplugged freezer and removed evaporator panel. Plugged unit back in and checked fan, coil "snap switch" and heater element, all seemed to check out good. Found defrost timer stuck in the freeze position, causing frost to accumulate over the evaporator. Manually rotated defrost timer to the 30min defrost cycle and system went into defrost. Ordered defrost timer and installed (part arrived in 3 days). Freezer works great again. Too bad I ended up throwing 400 dollars worth of meat away. the fix was very simple. Will definitely use PartSelect again. Thank you.

Just snapped the piece in place. Fixed in less than 1 minute. The Lady on the phone was helpful in making sure I was selecting the right piece. Delivery was made in 2 days. I can't be more pleased. cw

I had no problems. Screws arrived sooner than expected. It was a very simple installation. Very pleased with both the product and service.

Upluged power pulled freezer out from wall removed the two screws that holds the defrost timer unpluged defrost timer pluged new timer in mounted new timer back with the two screws pluged freezer back in and job was complete. Freezer working fine.

Initially, I traced the noise down to the evaporator motor area. I thought it was the fan blade so I ordered and changed it. Noise level better but still not good. Then I ivestigated problem area again. Removed the motor,discoverd that the motor shaft was loose /drifting which caused the "hummm" and uneven fan blade rotation. Orderd and installed new motor and all is good.

took off cardboard removed two screws holding fan housing. Removed new fan and housing from box and mounted new fan to new housing (two screws). Installed new fan and housing. reinstalled cardboard and plunged in power cord. Perfect fit.

Remove the cover panel inside the freezer, remove and replace the fan motor (pull fan blades off old motor and push on the new one) and replace the cover.

I unscrewed the screws that held the old fan on, disconnected the wiring harness and removed the old fan. I pulled the blades off the motor and put it on the new fan. One thing of note, the screw holes on the new fan weren't threaded. I assume this is by design, so I used the screws to thread the holes before installing it in the freezer. Once I did this, the rest of the installation was easy, just screw it back in and connect the wiring harness.

Removed old fan motor and installed new one.Not much room for big hands back there.Flexible extensions valuable on this job.

hooked it around the set knobs in the side panels.ordered the part on saturday received it on tuesday.excellent service.

I just put it in place and it was perfect. I want to say this company has the fastest shipping ever and the part they sent was exactly what I needed.Thank You!