59665934404 Kenmore Refrigerator - Instructions

Pull out the drawers and removed the old rail, place new rail in and return drawers. Like New and took about 3 minutes.

Snapped old one off, snapped new one on

The rail had broken off, so there was nothing to remove, except the crisper drawers. I had called an amana repair service and the repairman told the part was about $9 and the cost to install was $127. When I almost fainted, he told me I could probably do it myself. Wow, was he right! I ordered the part, it came in about 2 days, I looked at the rail, removed the glass shelf, hooked the rail into the little opening at the back, and bang! All done. It took me 10 seconds!!

Removed drawers, lifted glass shelf, installed new part

Just like the video showed me.It still does not work. Have to turn it off and on to make it start up.I also replaced thermostat in freezer. Does not work.

Followed easy instruction video. It was like new in fifteen minutes.

Removed the glass shelf, position the rail in its slots and replaced the glass shelves.

Removed both crispers and shelf . Inserted new rail as explained in video. Replaced everything.

Unplug the refrigerator and pull it out so you can work behind it.I had to get a helper to lean the refrigerator forward and let it rest on a towel I placed on the countertop. The tray was underneath the refrigerator near the back so I leaned it forward enough to remove the metal plate that holds the tray in place. I placed a scotch behind the front wheels to keep it from rolling backward off the counter it was resting on. I had to remove the cover from the unit on the lower back side of the refrigerator to see how the tray was moumted. Once you remove the plate you have to slide the fan off the tray and then you can remove the tray. Simply reverse the whole process to install the new tray, upright the refrigerator and plug it back in to the outlet.

Removed back cover. Removed fan with mount which was a little difficult. Installed new pan and parts that were removed. Part came in one day. Great service.

Dropped down the front control panel were you program the the tempertures when you open the doors. This just pops down from the front. Then change out the printed cicuit broad two wires all done.

I initially thought the defrost heater or sensor were bad and replaced them. About a week later the problem reappeared. I ordered the control board assembly and after arrival I did the following: Went on-line, located the part on the fridge parts diagrams and figured out how to remove the controller cover (use two flat screwdrivers from behind). After the cover removal unplug the two connectors and lift out the sensor from its mount. Remove the LED Display/Button Board then the microcontroller board. They literally lift out. With the new controller you have to gently break the display board from the controller - the board is scribed along the break-away area. Do this on a flat surface. The actual board installation and hook-up took less than 5 minutes to reassemble. MAKE SURE THE REFRIGERATOR IS UMPLUGGED - I should have said that FIRST.

Removed the storage bins. Removed the whole shelf, remove the glass part.(clean everything while you are at it, which is why it took 15-30 minutes) Lift out old rail and replace it with the new, reinstall shelf and glass. If you choose to not to clean, just take out the glass shelf, replace rail and put it back in. .

The instruction video was so helpful. I watched it before I ordered the part to be sure I was able to make the repair. The replacement part arrived quicker than I expected. Cleaning the shelf & bins was the most time consuming part of the job. The replacement part fit in place perfectly. My fridge is good as new again!

Removed the six screws holding the bottom access plate found at the rear of the refrigerator. This gives you easy access to the run capacitor that has a retaining clip. Remove the wire clip and pull out the capacitor (it has two quick disconnect terminals). Reverse the process using the new run capacitor to complete the repair.