59669982000 Kenmore Refrigerator - Instructions

Emptied and disassembled the freezer. Defrosted and dried the coils. Tested the defrost heater coil ( 50 ohms ) PRT and fan - all OK. Opened the lower back panel and cleaned the water collection tray. Vacuumed out all debris including coils underneath. Reassembled everything. Removed the old control board and installed the new board paying attention to ESD steps. Applied AC power. Programmed the new board per the video link ( nicely done ). 3 weeks later and the unit seems dry and happy. Running at lower settings with good temperature results. Suspect the 24VDC relay activating the defrost heater coil on the control board or what controls the relay not working. May pull relay for test.

It was so easy just opened the box took out the shelf and plaed it where the old one was. This was the easiest repair ever. Thank you for this website!

remove two crispers and glass top . Replace rail.
Note
This is 3rd time this part in about 5 years has needed replcement. If there is a next time I would expect a "freebe". Service is great and replacement rail came in jig time.

I noticed the coils very dusty dirty, tried brushing it clean, ended up blowing it clean. I noticed the condenser fan motor was never turning, I had power, so I ordered a new one. I actual received the evaporator motor, so I had to order the correct one. After changing it, and it started blowing right away. But my refrigerator is still warm. I do not know where the evaporator blower motor is located. I cannot make out from the diagram breakdown. HELP

First off, I learned from YTube how to go about figuring out what might be wrong & how to fix it. I watched numerous videos and narrowed it down to the damper as the part to be replaced. I learned how to use the Jazz Board in the fridge to test components & verified the damper wasn't getting signal to open/close. I removed the old damper & put in the new one following what I had seen on the videos. I found a video that had the same type of damper assembly as my fridge & used it to show me how to remove & replace the damper. This was the 2nd part I had to replace to get my fridge up & working. I spent a total of 224.00 on parts and now the fridge is quieter than it's been in years. Finally, if a 66 year old woman can do this, so can you. Just watch YTube & also PartsSelect also has videos also.

Used UTube directions the ones that came w/part we're too generic

Watched the video. Everything went great, Super simple

removed drsws and shelf put new center rail replaced draws done

I placed the back of the bracket into the slot in the rear of the refrigerator and stretched the front plastic rim on the glass shelf over the front of the new center rail until it snapped into place (all the while hoping I didn't cause further damage to my refridgerator!) and wa-la, piece of cake! My impatience paid off this time!

The entire process took lees than 5 minutes. I simply removed the broken rail, and inserted the new one. Voila! Like new!

Finding the part that I needed was incredibly easy. I usually leave all repairs to my husband but I was getting frustrated that my vegetables were freezing due to the drawer laying right on the wall dividing the freezer area. I took it upon myself to search for parts by using the refrigerator model number, This site is the BEST!! By providing pictures of the parts and where they go I was able to order the correct one. It arrived within a few days and I installed it in less than 5 minutes. I was relieved that I had ordered the correct part and my husband was pleasantly surprised that I took care of it myself. Thanks

I had to remove the 2 drawers, naturally, but then found I also had to remove the glass shelf and bracket that holds them, because the end of the center rail had broken off and stuck in the recess of the shelf. No problem. Washed the shelf and the end piece fell out, eliminating the need for pliers or tweezers. Put the new center rail in place, replaced the shelf, replaced the 2 crisper drawers and, "voila" - good as new (until next time some big, strong guy slams the crisper drawer). Thanks for quick delivery; I don't often get in the mood to fix things, so when I do it's nice the part arrives before my fixing-muse flies away.

The repair was easy ... but this Part Select will be my favorite forever!! The people on the phone were awesome ... the part came immediately ... and we couldn't be happier!!!

Thank you so much!! You're the best!!!

I took out the drawers, glass, and crisper frame and slid in the center crisper bar. I ordered 2 because it looks like the bar could easily break again!

I watched your video. The part came faster than expected. The video was very helpful. I am very happy with the service.