59667993608 Kenmore Refrigerator - Instructions

Noted the Damper Assemby in the upper rear of refrig section,was always staying open during checks for problems. Controls appeared to be controlling temp changes when adjusted. Pulled the damper assemby after removing two screws holding the diffuser/cover(diffuser pops off with screwdriver) Damper assembly snaps out , unplug wires, snap new damper assembly in place, reconnect wires at the plug, replace cover with foam insulation, secure with screws replace diffuser snaping in place. Recheck settings for desired temperatures.

Removed back cover. Removed fan with mount which was a little difficult. Installed new pan and parts that were removed. Part came in one day. Great service.

Unplug the refrigerator and pull it out so you can work behind it.I had to get a helper to lean the refrigerator forward and let it rest on a towel I placed on the countertop. The tray was underneath the refrigerator near the back so I leaned it forward enough to remove the metal plate that holds the tray in place. I placed a scotch behind the front wheels to keep it from rolling backward off the counter it was resting on. I had to remove the cover from the unit on the lower back side of the refrigerator to see how the tray was moumted. Once you remove the plate you have to slide the fan off the tray and then you can remove the tray. Simply reverse the whole process to install the new tray, upright the refrigerator and plug it back in to the outlet.

The unit has two fans on it. One is located in the back and the other is locate inside the freezer section behind the panel. Remove the four bolts holding the door to the sliding rack. Remove the ice machine. Remove the back panel. Noticed that the fan was covered in ice thus shorting the fan motor. Tested for voltage to the fan was good. Replaced evaporator fan motor and unit works perfectly

I watch a widea on part select 'how to do that' and was relly very easy to repleace a part. The delivery was next day. They are triting customers very serious and professionals. I'll recomended part select for all my friedds with similar problems. Thank you.

Thanks to some reviews we found online about replacing gaskets, ours went very smoothly. One person said to soak the gasket in hot water, which we did til it was very soft. Installed like a breeze. Then, the same person said to tape the door closed after installation, we did that too. The gasket looks like it was professionally installed and we have never done it before. Thanks!

Followed instructions supplied on Your website. Instuctions were well explained and easy to follow.

After plugging in the new relay to no avail. I replaced the thermostat. That fixed the problem.

Took off the shelf abovethe rail and slid into the receiver in back and front. BTW, cant say enough good about the customer service received from Part Select! They were awesome!

Remove plastic vent cover. Just snaps out. Take out two screws that hold damper cover on. Unclip and unplug damper assembly. Snap in new assembly and plug in. Replace covers. I was pretty sure this would fix my problem after observing the damper for several days. It would stay open and when I moved it by hand it would open a little more and then close. Easy fix!

Removed the two drawers and shelve. Inserted the new crisper rail. Replaced the two drawers and put the shelve back in. Took maybe 10 minutes. Did not need any tools.

I removed the glass on top of the Crisper and replaced the Rail and then replaced the glass. Done

I was so happy to find that i could order the part online and not have to call a repairman and pay for a service call. The prat shipped in one day! It was very easy to install. Only tip i will give is, make sure you put it in the right direction. If placed in wrong the drawers won't open.

It took more time to open the shipping box than to slide the drawer into place :-)

I did remove the run capacitor of the starthing kit of compressor and another one new. It work fine.