10657342701 Kenmore Refrigerator - Parts

Anti drip valve NOT included.

This part attaches to the drive shaft of the ice dispenser motor.

Sold Individually - Appliance originally takes 2.

This part is the top hinge for your refrigerator door. It is made of metal and is approximately 5 inches by 3 ¼ inches in size. This hinge is for the right side of the refrigerator door only. The left...

This white water filter cap fits at the base of the refrigerator to hold the filter securely in place. It installs easily with a simple twist—no tools needed. A durable and clean-looking replacement t...

This part may come with a plastic or metal auger depending on the factory. It will work with your appliance if found with the model number. (Make sure you install properly at back of ice container, be...

This clip is sold individually.

This dispenser door pin comes with the washer.

Support wheel assembly with bracket. Kit of 2.

The heater is located at the bottom of the evaporator. The defrost heater heats the evaporator in the defrost mode of operation. The thermostat must be replaced when replacing the defrost heater.

This door gasket is used to seal the refrigerator door when closed to keep the cool air inside and the room air out.

This is a kickplate, but you may also know it as a grate or a grille. It is a part for your refrigerator. The purpose of the kickplate is to allow air to circulate by flowing through the grates and in...