59669928011 Kenmore Refrigerator - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Sheila from Folsom, LA
- Parts Used:
- WPW10128551
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Nutdriver, Screw drivers
Fridge section too warm and freezer cold
The unit has two fans on it. One is located in the back and the other is locate inside the freezer section behind the panel. Remove the four bolts holding the door to the sliding rack. Remove the ice machine. Remove the back panel. Noticed that the fan was covered in ice thus shorting the fan motor. Tested for voltage to the fan was good. Replaced evaporator fan motor and unit works perfectly
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Burton from Pecatonica, IL
- Parts Used:
- WPW10662129
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Nutdriver
Heard a five second buzzing sound repeated 4 or 5 times per cycle coming from rear lower left compressor side.
Removed the six screws holding the bottom access plate found at the rear of the refrigerator. This gives you easy access to the run capacitor that has a retaining clip. Remove the wire clip and pull out the capacitor (it has two quick disconnect terminals). Reverse the process using the new run capacitor to complete the repair.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Richard A. from Boones Mill, VA
- Parts Used:
- WPW10196393
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Milk was freezing in Refig section, 28 F temp
Noted the Damper Assemby in the upper rear of refrig section,was always staying open during checks for problems. Controls appeared to be controlling temp changes when adjusted. Pulled the damper assemby after removing two screws holding the diffuser/cover(diffuser pops off with screwdriver) Damper assembly snaps out , unplug wires, snap new damper assembly in place, reconnect wires at the plug, replace cover with foam insulation, secure with screws replace diffuser snaping in place. Recheck settings for desired temperatures.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Bea from Grand Rapids, MI
- Parts Used:
- WPW10671238
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
The Rail broke
Removed the storage bins. Removed the whole shelf, remove the glass part.(clean everything while you are at it, which is why it took 15-30 minutes) Lift out old rail and replace it with the new, reinstall shelf and glass. If you choose to not to clean, just take out the glass shelf, replace rail and put it back in. .
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Kathryn from Oceanside, NY
- Parts Used:
- WPW10671238
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
original rail cracked
The instruction video was so helpful. I watched it before I ordered the part to be sure I was able to make the repair. The replacement part arrived quicker than I expected. Cleaning the shelf & bins was the most time consuming part of the job. The replacement part fit in place perfectly. My fridge is good as new again!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Laura from Fort Lauderdale, FL
- Parts Used:
- WPW10671238
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
rail that is the glide for the crisper drawers broke
I was so happy to find that i could order the part online and not have to call a repairman and pay for a service call. The prat shipped in one day! It was very easy to install. Only tip i will give is, make sure you put it in the right direction. If placed in wrong the drawers won't open.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Janis from Cedarburg, WI
- Parts Used:
- WPW10671238
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
We had a broken center crisper rail in our Maytag Refrigerator
Followed the instructions on the website. Removed glass shelf, installed rail and replaced salad crisper bins and glass shelf. Less than 5 minutes!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- carol from decatur, IN
- Parts Used:
- WPW10671238
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
The center crisper rail broke.
First of all, I watched the very helpful video on your site, when the part arrived, I installed the rail all by myself...I am a female, and it was very easy..thank you for the video information, very helpful..
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Lynne M. from York, PA
- Parts Used:
- WPW10671238
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Flange on the original center crisper rail cracked off
Not including the time I spent to thoroughly clean the shelf, 2 crisper bins and the bottoms and sides of the inside of the refrigerator, having been faced with the obvious opportunity, this job takes about 30 seconds! After clearing, carefully lift the glass shelf from its frame, remove the broken rail and insert the new rail. Lower the glass shelf into the frame. Voila! Fini!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Barbara from Beverly, MA
- Parts Used:
- WPW10671238
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
center crisper rail broke-think i put too much weight on it.
just replaced the one part-fit right in---great
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- hilary from BAINBRIDGE ISLAND, WA
- Parts Used:
- WPW10671238
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
slide mount for veggie crispers broke
Pulled out broken part, slid in new one, put drawers back in. Works great. Website to find and order part was super easy to use and part came quickly. Two thumbs up.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Waynesboro After from Waynesboro, PA
- Parts Used:
- WPW10671238
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Broken Crisper Rail
Clean off the glass shelf, remove drawers and shelf, pop in replacement rail, put everything back in fridge. Replacing the part is the easy part, what I would like to know is why this is the second one I have had to buy this year. There must be a problem with the replacement parts that they break so easily. This time, I bought 2, so that i have a spare - fortunately, the price is reasonable.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- cindy from merrill, WI
- Parts Used:
- WPW10671238
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Center crisper rail broke, so repaired it.
Removed the drawers and shelf with glass t.op and center rail, installed new one (popped out and popped new one in). Took all of 5 minutes. Easy to order on line. Should use usps for shipping it is cheaper.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Ann from Shrewsbury, MA
- Parts Used:
- WPW10671238
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Broken tabs on ends of Center Crisper Rail
First I watched the How To video on the repair process. Then I followed the steps on the video and was finished in no time at all. Very simple! The ordering and delivery of the product was also quick and efficient.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- LaViece from Texas, TX
- Parts Used:
- WPW10671238
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Center rail for the crispers broke
I did it exactly how the video that was shown when I purchased the new rail. Following those instructions worked perfectly.
Was this instruction helpful to you?
Thank you for voting!