10655422501 Kenmore Refrigerator - Parts

The heater is located at the bottom of the evaporator. The defrost heater heats the evaporator in the defrost mode of operation. The thermostat must be replaced when replacing the defrost heater.

This fan motor circulates the air through the refrigerator grille and cools the compressor and condenser coils. It also helps to evaporate extra water in the drain pan. Please note: If the original fa...

This door gasket is used to seal the refrigerator door when closed to keep the cool air inside and the room air out.

This is a kickplate, but you may also know it as a grate or a grille. It is a part for your refrigerator. The purpose of the kickplate is to allow air to circulate by flowing through the grates and in...

This part strips ice from the icemaker mold during the ejection cycle to prevent ice pieces from falling back into the mold.

16ml

This is a decorative front cover that is made of plastic that covers the opening to where the icemaker is located and disables contact by the user while the icemaker is engaged.

Once a glass is pressed against the actuator pad it will cause the dispenser to deliver water when activated.

This motor rotates the auger. When the auger rotates, it pushes ice out of the bin, through a chute to the user.

This white icemaker assembly washer is less than an inch long.

This door gasket is used to make an air-tight seal for the cabinet when the door is closed.

Sold Individually - 2 screws needed to mount each handle.