10654586401 Kenmore Refrigerator - Parts

This dispenser door pin comes with the washer.

This door gasket is used to seal the freezer door when closed.

Support wheel assembly with bracket. Kit of 2.

The heater is located at the bottom of the evaporator. The defrost heater heats the evaporator in the defrost mode of operation. The thermostat must be replaced when replacing the defrost heater.

This part strips ice from the icemaker mold during the ejection cycle to prevent ice pieces from falling back into the mold.

16ml

This is a decorative front cover that is made of plastic that covers the opening to where the icemaker is located and disables contact by the user while the icemaker is engaged.

This motor rotates the auger. When the auger rotates, it pushes ice out of the bin, through a chute to the user.

This white icemaker assembly washer is less than an inch long.

Sold Individually - 2 screws needed to mount each handle.

This part consists of a cube and arm that upon activation opens the ice container gate and allows the ice cubes to enter into the chute and into the ice and water dispenser.

Once a glass is pressed against the actuator pad it will cause the dispenser to deliver ice when activated.