59668049802 Kenmore Refrigerator - Instructions

Like you video

Not so good that was not the problem. Fan is not seized and all the lights work and display is not on but lights up as well. No start once plugged back in after 15 minutes of being unplugged. Nothing same no change.

It was easy, remove clips and install new basket hanger and then just clip on the clips.

The Condenser Fan Motor was already removed due to searching for the problem. The new fan motor looked different from the original but I felt very comfortable that Part Select had sent me the new part showing original part number changing numbers over the years. Simply placed the fan blades onto the new motor lined up 2 of the holes placed screws and tightened then plugged the wire ribbon into the Condensor Fan Motor, plugged in the Refridgerator and it worked beautifully.

The instruction video on the Part Select Web Site made it so incredibly easy to install. Installation took under 3 minutes!

Was told capacitor was problem 90% of the time.Capacior was not the problem.Bad start relay.

Used the suggested problem list here to narrow down that the repair was most likely the run capacitor. Poped the new one in and I now have better control of my compartment ranges. I have a temperature gauge in each compartment. Check them every opening of the doors.

Removed & Replaced

First off, I learned from YTube how to go about figuring out what might be wrong & how to fix it. I watched numerous videos and narrowed it down to the damper as the part to be replaced. I learned how to use the Jazz Board in the fridge to test components & verified the damper wasn't getting signal to open/close. I removed the old damper & put in the new one following what I had seen on the videos. I found a video that had the same type of damper assembly as my fridge & used it to show me how to remove & replace the damper. This was the 2nd part I had to replace to get my fridge up & working. I spent a total of 224.00 on parts and now the fridge is quieter than it's been in years. Finally, if a 66 year old woman can do this, so can you. Just watch YTube & also PartsSelect also has videos also.

I noticed the coils very dusty dirty, tried brushing it clean, ended up blowing it clean. I noticed the condenser fan motor was never turning, I had power, so I ordered a new one. I actual received the evaporator motor, so I had to order the correct one. After changing it, and it started blowing right away. But my refrigerator is still warm. I do not know where the evaporator blower motor is located. I cannot make out from the diagram breakdown. HELP

remove two crispers and glass top . Replace rail.
Note
This is 3rd time this part in about 5 years has needed replcement. If there is a next time I would expect a "freebe". Service is great and replacement rail came in jig time.

removed drsws and shelf put new center rail replaced draws done

Watched the video. Everything went great, Super simple

I had to remove the 2 drawers, naturally, but then found I also had to remove the glass shelf and bracket that holds them, because the end of the center rail had broken off and stuck in the recess of the shelf. No problem. Washed the shelf and the end piece fell out, eliminating the need for pliers or tweezers. Put the new center rail in place, replaced the shelf, replaced the 2 crisper drawers and, "voila" - good as new (until next time some big, strong guy slams the crisper drawer). Thanks for quick delivery; I don't often get in the mood to fix things, so when I do it's nice the part arrives before my fixing-muse flies away.

Pull out the drawers and removed the old rail, place new rail in and return drawers. Like New and took about 3 minutes.

Easy as pie: removed the baskets; lifted the shelf; placed new rail; replaced shelf & baskets.