Models > 59669912010 > Instructions

59669912010 Kenmore Refrigerator - Instructions

Jump to:

All Instructions for the 59669912010

Customer:: Sheila from Folsom, LA
Parts Used:: WPW10128551
Difficulty Level:: Easy
Total Repair Time:: 15 - 30 mins
Tools:: Nutdriver, Screw drivers

Fridge section too warm and freezer cold

The unit has two fans on it. One is located in the back and the other is locate inside the freezer section behind the panel. Remove the four bolts holding the door to the sliding rack. Remove the ice machine. Remove the back panel. Noticed that the fan was covered in ice thus shorting the fan motor. Tested for voltage to the fan was good. Replaced evaporator fan motor and unit works perfectly

Was this instruction helpful to you?

Customer:: Warren from Flanders, NJ
Parts Used:: WPW10655367
Difficulty Level:: A Bit Difficult
Total Repair Time:: 30 - 60 mins
Tools:: Nutdriver, Wrench (Adjustable)

Old drip pan had many cracks and leaked

Removed back cover. Removed fan with mount which was a little difficult. Installed new pan and parts that were removed. Part came in one day. Great service.

Was this instruction helpful to you?

Customer:: Elmer R from Jenkins, KY
Parts Used:: WPW10655367
Difficulty Level:: Really Easy
Total Repair Time:: 30 - 60 mins
Tools:: Screw drivers

The tray that catches the defrost drainage was cracked and leaking.

Unplug the refrigerator and pull it out so you can work behind it.I had to get a helper to lean the refrigerator forward and let it rest on a towel I placed on the countertop. The tray was underneath the refrigerator near the back so I leaned it forward enough to remove the metal plate that holds the tray in place. I placed a scotch behind the front wheels to keep it from rolling backward off the counter it was resting on. I had to remove the cover from the unit on the lower back side of the refrigerator to see how the tray was moumted. Once you remove the plate you have to slide the fan off the tray and then you can remove the tray. Simply reverse the whole process to install the new tray, upright the refrigerator and plug it back in to the outlet.

Was this instruction helpful to you?

Customer:: Kathryn from Oceanside, NY
Parts Used:: WPW10671238
Difficulty Level:: Really Easy
Total Repair Time:: 15 - 30 mins

original rail cracked

The instruction video was so helpful. I watched it before I ordered the part to be sure I was able to make the repair. The replacement part arrived quicker than I expected. Cleaning the shelf & bins was the most time consuming part of the job. The replacement part fit in place perfectly. My fridge is good as new again!

Was this instruction helpful to you?

Customer:: Richard A. from Boones Mill, VA
Parts Used:: WPW10196393
Difficulty Level:: Really Easy
Total Repair Time:: 15 - 30 mins
Tools:: Screw drivers

Milk was freezing in Refig section, 28 F temp

Noted the Damper Assemby in the upper rear of refrig section,was always staying open during checks for problems. Controls appeared to be controlling temp changes when adjusted. Pulled the damper assemby after removing two screws holding the diffuser/cover(diffuser pops off with screwdriver) Damper assembly snaps out , unplug wires, snap new damper assembly in place, reconnect wires at the plug, replace cover with foam insulation, secure with screws replace diffuser snaping in place. Recheck settings for desired temperatures.

Was this instruction helpful to you?

Customer:: Bea from Grand Rapids, MI
Parts Used:: WPW10671238
Difficulty Level:: Really Easy
Total Repair Time:: 15 - 30 mins

The Rail broke

Removed the storage bins. Removed the whole shelf, remove the glass part.(clean everything while you are at it, which is why it took 15-30 minutes) Lift out old rail and replace it with the new, reinstall shelf and glass. If you choose to not to clean, just take out the glass shelf, replace rail and put it back in. .

Was this instruction helpful to you?

Customer:: Burton from Pecatonica, IL
Parts Used:: WPW10662129
Difficulty Level:: Easy
Total Repair Time:: 15 - 30 mins
Tools:: Nutdriver

Heard a five second buzzing sound repeated 4 or 5 times per cycle coming from rear lower left compressor side.

Removed the six screws holding the bottom access plate found at the rear of the refrigerator. This gives you easy access to the run capacitor that has a retaining clip. Remove the wire clip and pull out the capacitor (it has two quick disconnect terminals). Reverse the process using the new run capacitor to complete the repair.

Was this instruction helpful to you?

Customer:: Sherry from Columbiaville, MI
Parts Used:: W11177593
Difficulty Level:: Easy
Total Repair Time:: 15 - 30 mins
Tools:: Screw drivers

Freezer seal was broken

Thanks to some reviews we found online about replacing gaskets, ours went very smoothly. One person said to soak the gasket in hot water, which we did til it was very soft. Installed like a breeze. Then, the same person said to tape the door closed after installation, we did that too. The gasket looks like it was professionally installed and we have never done it before. Thanks!

Was this instruction helpful to you?

Customer:: Waynesboro After from Waynesboro, PA
Parts Used:: WPW10671238
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins

Broken Crisper Rail

Clean off the glass shelf, remove drawers and shelf, pop in replacement rail, put everything back in fridge. Replacing the part is the easy part, what I would like to know is why this is the second one I have had to buy this year. There must be a problem with the replacement parts that they break so easily. This time, I bought 2, so that i have a spare - fortunately, the price is reasonable.

Was this instruction helpful to you?

Customer:: cindy from merrill, WI
Parts Used:: WPW10671238
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins

Center crisper rail broke, so repaired it.

Removed the drawers and shelf with glass t.op and center rail, installed new one (popped out and popped new one in). Took all of 5 minutes. Easy to order on line. Should use usps for shipping it is cheaper.

Was this instruction helpful to you?

Customer:: Neil G. from Laconia, NH
Parts Used:: WPW10671238
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins

Center Crisper Rail Broke

Followed instructions supplied on Your website. Instuctions were well explained and easy to follow.

Was this instruction helpful to you?

Customer:: Ed from Varna, IL
Parts Used:: WPW10671238
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins

Crisper rail broke

Took off the shelf abovethe rail and slid into the receiver in back and front. BTW, cant say enough good about the customer service received from Part Select! They were awesome!

Was this instruction helpful to you?

Customer:: Robert from Decatur, GA
Parts Used:: WPW10196393
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins
Tools:: Screw drivers

Food Freezing

Remove plastic vent cover. Just snaps out. Take out two screws that hold damper cover on. Unclip and unplug damper assembly. Snap in new assembly and plug in. Replace covers. I was pretty sure this would fix my problem after observing the damper for several days. It would stay open and when I moved it by hand it would open a little more and then close. Easy fix!

Was this instruction helpful to you?

Customer:: Jeannette from Cadiz, KY
Parts Used:: WPW10671238
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins

Center Crisper Rail Broke

Removed the two drawers and shelve. Inserted the new crisper rail. Replaced the two drawers and put the shelve back in. Took maybe 10 minutes. Did not need any tools.

Was this instruction helpful to you?

Customer:: Robert from Cusseta, AL
Parts Used:: WPW10671238
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins

Center Crisper Rail

I removed the glass on top of the Crisper and replaced the Rail and then replaced the glass. Done

Was this instruction helpful to you?

All Instructions for the 59669912010