Models > 25361534806 > Instructions

25361534806 Kenmore Refrigerator - Instructions

Jump to:

All Instructions for the 25361534806
46 - 60 of 109
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
Salvador from SANTA ANA, CA
Parts Used:
5303918202
Difficulty Level:
Very Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Pliers
Freezer worked, refrigerator didn't. Ice build up on coils.
Unplugged refrigerator. Emptied freezer and removed ice maker and cover, need to unplug fan. Defrosted coils with hot water. Cut wires to thermostat as close to it ad possible to leave extra wire in case of an error. Stripped wire in new thermostat and put in shrink plastic then the wire crimp connector joining both light blue wires making sure wires were in before crimping them. Repeated with other dark blue wire. After used the heat gun to shrink the protective white tubing. The only thing i found not satisfying was tge tubing. It was too wide and too small. When i shrunk it did not cover the whole connector and was loose. I had to use a glue gun to cover both ends of each wire connector. Hope this helps other users.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Robert from MONTGOMERY, IL
Parts Used:
5303918202
Difficulty Level:
Very Easy
Total Repair Time:
15 - 30 mins
Tools:
Socket set
Coils frozen over. Refrigerator not cooling
I cut wires from bad thermostat and removed it . Stripped wires and crimped connectors on new thermostat and wires from old thermostat. Used heat gun to seal sleeves over connectors. Very helpful video from this site Thanks, you will be my go to parts supplier from now on!!!!!!!!!!!!
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
will from bushnell, IL
Parts Used:
5303918202
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Tools:
Nutdriver
Freezer froze up/ Fridge ran warm
Thawed out freezer, I recommend laying a couple old towels in freezer to soak up melted ice. Replaced old thermostat with new part. Removed 2 screws, removed back plate, unplugged 2 connectors and cut 2 wires. Crimped in new thermostat and repositioned to original part location. Reconnected plugs as I reinstalled back plate. Installed 2 screws and connected power. Works like new! Trouble shooting and part installation video is very helpful, great site!
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Guillermo from HAWTHORNE, NJ
Parts Used:
240535101, 240535201
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Door racks broken
Refrigerator door racks broken.
Removed old ones and replaced with new door racks. Just snap on.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Laura from RAPID CITY, SD
Parts Used:
240535201
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Broken door rack
The repair was very easy just popped the new one in place.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
David from ABINGDON, VA
Parts Used:
5304464438
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
Fridge would not cool at all, because the compressor was not running. Fan running, lights working, just no cool.
Remove the cardboard access cover at the bottom back of the fridge. On the left side, locate the run capacitor. Remove it by prying it loose from its socket, after first removing the wire hold down clamp. One wonders why the clamp is there, which makes it difficult to get the run capacitor out. Be careful not to disrupt in any way the copper refrigerant tubes. If you mess them up, you will have wasted your time and effort trying to repair the machine. I was lucky, since a failed run capacitor is the problem only about 12% of the time, based on what I’ve read. Hallelujah! It was the problem with my fridge.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
JACOB from YOUNGSTOWN, OH
Parts Used:
241537103
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Refrigerator did not cycle
Installation was fairly straight forward. The major complaint is that the problem returned 2 weeks later. I don’t know if I care to re-invest in another switch.
Now what?
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Karla from UNION, MO
Parts Used:
241554901
Difficulty Level:
Difficult
Total Repair Time:
1- 2 hours
Tools:
Socket set
Refrigerator light stopped working
The bulb wasn't the issue so I was hopeful the switch was. utube helped me some, but figuring my model was different than any on utube. Got the switch in and plugged it back in. Moment of truth. Didn't light. Ugggh! Out $50 for switch plus $20 for nut driver set.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Elizabeth from CONCRETE, WA
Parts Used:
240535301
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Top door rack Part #: PS735098
Figuring out how to remove the cracked door rack was the most complication I had. Once I figured out how to push it up it was easy to remove and then replace it with the new part by just placing it over the nobs and pushing down. No tools needed, just hands.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Duarte from SEDRO WOOLLEY, WA
Parts Used:
242077705
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Pliers
the refrigerator stop making ice and only the bottom part was cooling
first i order a defrost termostate i replace it but wasnt the problem then i
unpluged the evaporator fan motor and test it and was not working order
a new one and working like new.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Donna from EDGERTON, OH
Parts Used:
240535201
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Was broken
The repair was not the issue. When I received it there was no protection packing, no invoice and if you call the number, no one is there to help. The rack was plastic with no protection in box and it was damaged. Tried to resolve this matter with no response. Will never go through part select again.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Judy from ROYSE CITY, TX
Parts Used:
5304464438
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Freezer wasn't cooling - compressor not engaging
Ordered the Capacitor and the Thermostat Control. Parts were received in a matter of a few days, easy to install, but did not fix the problem. Had to call a repairman to fix the problem (compressor relay - this part not available to order for this model number with Parts Select). Will continue to use Parts Select in the future for other parts, but not happy that the actual part I needed was not available - had to use other methods.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Nancy from SELINSGROVE, PA
Parts Used:
240535101
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Shelf rack broke.
Ordered part easily with modal number ( they tell you where to find it). Received quickly and snapped paper in. They also had a video instruction. Will definitely use again!
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Margaret from NEW YORK, NY
Parts Used:
240535101
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Door rack broke
Ordered new one. Popped it in. Very Very easy
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Sadrudin from SAN DIEGO, CA
Parts Used:
218396700
Difficulty Level:
Difficult
Total Repair Time:
30 - 60 mins
The hole on the handle mounting block was too low
I had to loosen the screw holding the mounting block and increase the hole size to fit the screw on refrigerator
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the 25361534806
46 - 60 of 109