Models > 2536080240E > Instructions

2536080240E Kenmore Refrigerator - Instructions

Jump to:

All Instructions for the 2536080240E

Customer:: steve from Kirkland, WA
Parts Used:: 215846602
Difficulty Level:: Really Easy
Total Repair Time:: 15 - 30 mins
Tools:: Screw drivers

freezer worked frig was warm. Ice maker is still not working

Removed two screws to get to defrost time pull panel down remove two screws holding time and reinstall

0 of 1 people found this instruction helpful.

Was this instruction helpful to you?

Customer:: Leonard from Harlingen, TX
Parts Used:: 241872503
Difficulty Level:: Really Easy
Total Repair Time:: 15 - 30 mins
Tools:: Screw drivers

Ice build-up in freezer; gasket needed replacing

It is easier to remove the door, put towels over the goods in the freezer and put the door on a flat surface. Pry up the old gasket gently; it just snaps in, so don't worry. Snap in the new gasket, screw the door back on, and you're set to go. We were scared at first, but it's really a simple operation.

0 of 1 people found this instruction helpful.

Was this instruction helpful to you?

Customer:: LUIS from CENTENNIAL, CO
Parts Used:: 215846602
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins
Tools:: Screw drivers

Freezer built ice, fridge not cold enough and running constantly.

Removed front low grill, removed the two screws that hold the element in place. I then pulled the element out about 3 inches and disconnected the wires. Reversed process to install new timer.

1 of 4 people found this instruction helpful.

Was this instruction helpful to you?

Customer:: linh from palmdale, CA
Parts Used:: 242193213
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins

the freshfood door of refrigerator can not close.

take of the old gasket, clean and put the new one on ...that's it....so easy...

2 of 7 people found this instruction helpful.

Was this instruction helpful to you?

Customer:: Ronald from Defiance, OH
Parts Used:: 215846602
Difficulty Level:: Really Easy
Total Repair Time:: 15 - 30 mins
Tools:: Nutdriver, Screw drivers

leaking water down into fridge

just like the video showed...it was excellent!!!

0 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Customer:: Thomas from Stuart, FL
Parts Used:: 215846602
Difficulty Level:: Really Easy
Total Repair Time:: 15 - 30 mins
Tools:: Nutdriver, Screw drivers

coil Iceing up

took 4 screws out of the discharge vent on top of the refrigerator section and unpluged the wiring harness and put the section on the counter and unscrewed the timer and put the new one in and reinstalled the assembly and plugged the Jack and put the 4 screws back in, and rotated the timer and put it on defrost removed the back and check the heaters and drain .

0 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Customer:: Joe from Woodbridge, VA
Parts Used:: 240534701
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins

Retainer bar on door snapped

It's a pressure fit. Squeeze the ends and snap it in.

0 of 3 people found this instruction helpful.

Was this instruction helpful to you?

Customer:: daryl from n.las vegas, NV
Parts Used:: 215846602
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins

frig side not cool/freezer coils not defrosting

unplugged frig,removed bottom front cover and loosend 2 screws at bottom front left and slid defrost timer out from behind metal panel,unplugged the old and plugged in the new.frig works great.

Was this instruction helpful to you?

Customer:: Nancy from Bellerose Manor, NY
Parts Used:: 240530811
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins

Needed new drawer for refrigerator to replace broken one.

I broke my drawer on a holiday Monday and Tuesday morning I had the new one in. your party was an exact match, even though the description said it might not be.

Was this instruction helpful to you?

Customer:: Michael E from Uniontown, PA
Parts Used:: 215846602
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins
Tools:: Nutdriver, Screw drivers

freezer was freezing and no refrigerator

Followed instruction vedeo from partselect. THANKS!!!!!

Was this instruction helpful to you?

Customer:: Kelli from Great Falls, MT
Parts Used:: 240534701
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins

door rack broke

Repair was very simple - just ordered the part and snapped it in. Very prompt service!!! Thank you!

Was this instruction helpful to you?

Customer:: nestor from Edinburg, TX
Parts Used:: 242193213
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins
Tools:: Screw drivers

door wont close

its real easy, just by pulling the old gasket, in some spots the gasket was like glued, but with a flat screw driver a managed to pulled apart. finally,just attached the new gasket.

Was this instruction helpful to you?

Customer:: Jessica from Canton, MI
Parts Used:: 242193213
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins

The gasket was torn and missing some chunks in some areas.

I did not believe the other posts about how easy this was because that is not at all how any project goes for me. I was wrong. The original gasket slid out of the lip around the door and the new one went back on in less than 5 minutes. It has made a HUGE difference in the performance of the fridge. It did take 2 or 3 days for the gasket to fully conform to the fridge itself, but there was still a good seal during that time.

Was this instruction helpful to you?

Customer:: Georgia from Bonners Ferry, ID
Parts Used:: 240534701
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins

2 door shelf retainers missing when bought refrig used.

Snapped retainers into place with no tools. Took less than a minute.

Was this instruction helpful to you?

Customer:: Ronald from West Springfield, MA
Parts Used:: 242193213, 240534701
Difficulty Level:: A Bit Difficult
Total Repair Time:: Less than 15 mins
Tools:: Screw drivers, Socket set

BROKEN door gasket

i read on line that it is easier to install the door gasket if you remove the door which also involves taking the freezer door off. start at the top and work your way down. easier with two people but one person can do it.not difficult, just press the gasket into the groove and the closing of the door will adjust it as is is needed.knowing this sequence will save you time.

Was this instruction helpful to you?

All Instructions for the 2536080240E