10650509990 Kenmore Refrigerator - Parts

This part may come with a plastic or metal auger depending on the factory. It will work with your appliance if found with the model number. (Make sure you install properly at back of ice container, be...

This OEM hinge kit includes the lower left and right hinges for both the refrigerator and freezer doors. It helps the doors open and close smoothly, stay aligned, and seal properly. Compatible with ma...

This kit no longer includes the connectors. It is only the tubing/water reservoir. Note: This tubing requires an adapter coupler (PS369735) to take the tubing from 1/4 inch to 5/16 inch.

This clip is sold individually.

This dispenser door pin comes with the washer.

This kit includes the Relay, Overload and cover. The start relay briefly boosts the compressor, and then shuts off as soon as the motor gets up to speed and the Overload provides added protection f...

This door gasket is used to seal the freezer door when closed.

Support wheel assembly with bracket. Kit of 2.

The heater is located at the bottom of the evaporator. The defrost heater heats the evaporator in the defrost mode of operation. The thermostat must be replaced when replacing the defrost heater.

This door gasket is used to seal the refrigerator door when closed to keep the cool air inside and the room air out.

This is a kickplate, but you may also know it as a grate or a grille. It is a part for your refrigerator. The purpose of the kickplate is to allow air to circulate by flowing through the grates and in...

This part strips ice from the icemaker mold during the ejection cycle to prevent ice pieces from falling back into the mold.