25370085614 Kenmore Refrigerator - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Justino from Kansas City, KS
- Parts Used:
- 242193213
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Torn refrigerator door gasket
We had no problem at all. My youngest brother and my 9 year old Son installed it. I was not there at the time but I assume it took no longer than 30 minutes. Thanks so much. Justino
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Vanessa from Alexandria, IN
- Parts Used:
- 242193213
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
installed new door strip
very easy. took the door off and new strip went on very easily.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Lawrence from Stow, OH
- Parts Used:
- 241796405
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Pliers
Ice Maker not getting any water
1). Shut off water supply to fridge. 2). Move fridge out to gain access to back of fridge. 3). Remove poly line to water tube have a glass handy to catch any remaining water that might be in line. Some may have a foam insulating washer around water tube remove it first. 4). My Sears-Kenmore was a twist lock water tube have to turn it to left or right depending on brand to remove tube. 5). After removing make sure tube didn't just have water frozen in tube ( that was my problem ) run it under hot water frozen piece will come out. 5). Problem fixed, reverse directions to re-install tube!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Paul from Akron, OH
- Parts Used:
- 241798231
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Nutdriver
Ice maker quit working.
The two screws that held the ice maker in place could not be seen do to there location. I could only get one hand inside do to space restriction.So I placed a mirror inside so I could see the screw heads and from point it was very easy to see and line up the nut driver on the screw heads. I then lifted it up and unplugged the wiring and installed the new ice maker. Works like a charm. Paul
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Al from Sarver, PA
- Parts Used:
- 240313703
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Nutdriver
Original plastic hinge cracked across the middle
Removed 2 hex screws & old hinge, placed new hinge on cabinet & found that it didn't fit; one hole was about 1/8" off. Had to drill a new hole in cabinet top in order to attach new hinge. Hinge works fine now. I'm glad to find the hinge is metal; original one was plastic.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- PAT from BATON ROUGE, LA
- Parts Used:
- 241796405
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
Water Tube That Fills Ice Maker Leaking Water
Undone the water line that comes up the back of the refrigerator and pulled the water tube out the back of the refrigerator and reinstalled the new one and reinstalled the water line. Done
Was this instruction helpful to you?
Thank you for voting!
Refrigerator door sagged, had to push the door to close it.
Used wood blocks to raise the door off the lower hinge bracket then unscrewed the suspect hinge. Cut a small shim, two layers of soda can, to place under the lower edge of the new hinge bracket and doubled the washers by using the old one to ensure I had adequate clearance for the door. After a little silicone lube I installed the new hinge bracket. All better now.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Kelli from Great Falls, MT
- Parts Used:
- 240534701
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
door rack broke
Repair was very simple - just ordered the part and snapped it in. Very prompt service!!! Thank you!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- nestor from Edinburg, TX
- Parts Used:
- 242193213
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
door wont close
its real easy, just by pulling the old gasket, in some spots the gasket was like glued, but with a flat screw driver a managed to pulled apart. finally,just attached the new gasket.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Michael from Katy, TX
- Parts Used:
- 242193213
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
torn door gasket
Opened refrigerator door, opened a Corona, took a sip,removed old gasket from its track by simply pulling out of the track with my fingers; took another sip, installed new gasket by lining it up and pressing it into the track with my thumbs (It's good to have opposal digits) starting at the top center and progressing clockwise, closed refrigerator door, minus one Corona. Sat on the patio and enjoyed the rest of my Corona. Life's good!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Jay from Bethel Park, PA
- Parts Used:
- 242193213
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Cracked gasket on fridge door
Used screwdriver to pry off edge of old gasket corner and peeled off old gasket. Snapped new gasket into door channel and made sure all the edges were seated. Took longer to open the shipping package than to do the repair.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- James from Dorchester, MA
- Parts Used:
- 240534701
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
broken shelf bar
removed broken bar and slipped in new bar
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- HCMA Benefits from Fairburn, GA
- Parts Used:
- 240350609
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Broken Glass Pan Cover
Put the glass in slot and it fit perfectly
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Francis from Buffalo, NY
- Parts Used:
- 240534701
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Door Shelf Retainer bar cracked
I just snapped the old one off , and then I snapped the new one on. Simple!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Vicki from St. Augustine, FL
- Parts Used:
- 240534701
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Door Shelf Retainer Bar Was Broken
I just snapped-on the bar to the refrigerator door. It took less than 30 seconds and the repair was complete! I am so happy!
Was this instruction helpful to you?
Thank you for voting!