10650042717 Kenmore Refrigerator - Instructions

auger blade was replace

After watching a video on you tube, the repair was very simple and easy.

I installed a Ice Door Kit. It works Great Now!

Everything worked perfectly---thanks to the suggestion of your call center agent. She suggested that since the replacement door handles were no longer available, I should consider repainting them--it worked like a charm. Please tell her she was a life saver. We rent that house in Fl and my returning tenants had complained about the discoloring refer handles. Thank you

shook bottle and painted waited a day and repeated

I had several times tried to get the old switch out but with no success. Ordered the "repair kit" and followed directions for removing old switch (there is a plastic spring clip on one side). Easy to unplug the old switch, plug the leads into the new one, snap the new one into place. Took about 5 minutes total--piece of cake. I wish I'd thought to try this years ago when the old switch began to fail.

I did remove the run capacitor of the starthing kit of compressor and another one new. It work fine.

Was easy, removed several screws and a clip on the auger shaft. removed broken part and replace with new then reassembled

I simply watched the repair video and did it! Super easy, needed start device and capacitor. As easy as unplugging the old and adding the new. The video helped and gave me confidence. Wives can fix fridges too! Saved me $2500. Looks like I'll need a new excuse if I want a new fridge.

We used the video out on YouTube to show us how to replace the drum. It made the repair go so fast that we were amazed that two klutzes could do this repair! Remove the screws that hold the housing together. Place the screws in a cup to keep everything together. Remove the spiral unit and the plastic sleeve. The hardest part was removing the auger nut on the assembly. Just remember it is a left hand turn. After that, remember sequence of the blade assembly. The video suggested that you take a picture and that would help remembering the sequence of the blades. Follow the video!

After years of using a flash light to check the contents of my refrigerator, I decided to try to fix the problem myself. Replacing the light switch was very easy. The directions were straight forward and I'm sorry I waited so long to tackle the problem.

Watched Video - took you through step by step

Replacement was quite easy. Video was helpful as to how to get all pieces back on the shaft correctly. Was easy to find the correct part and was shipped quickly.

My husband and I followed the instructional video on how to replace the "direct drive drum". We took note of how everything looked prior to dismantling the ice bin. We made sure we had the proper tools and a large flat surface to work on and started taking out the screws. Replaced the new drive drum part and put it all back together. The whole process took approximately 30 minutes and the ice crusher works great now. I'm a happy camper!!

The reason it took me longer than what should have been a 15 minute repair is due to the fact that I could not figure out how the shaft came apart. I found an instructional video on Parts Select website that showed me that the shaft was held together by a reverse treaded, round nylon nut on the very front of the shaft. Just use a pair of pliers to grasp the nut and rotate it clockwise, after that you just need to lay the parts out in order as they come off the shaft so you can put it back together again.