Models > 10651779510 > Instructions

10651779510 Kenmore Refrigerator - Instructions

Jump to:

All Instructions for the 10651779510

Customer:: Lori from Chuluota, FL
Parts Used:: W11384469
Difficulty Level:: Easy
Total Repair Time:: Less than 15 mins
Tools:: Screw drivers

There was no light on in refrig area

Just replaced the switch, but unfortunately that was not the problem; nor was it the bulb....so I am back to square one.
But Parts Select is a great place to order from. Thank you.

12 of 19 people found this instruction helpful.

Was this instruction helpful to you?

Customer:: Ray from KILL DEVIL HL, NC
Parts Used:: W10873791
Difficulty Level:: Really Easy
Total Repair Time:: 30 - 60 mins
Tools:: Nutdriver, Screw drivers

Ice maker quit making ice

1 turned off the unit
2 removed the cover panel be removing 4 Phillips head screws
3 unplugged the on off switch attached to the cover panel
4 removed the two 1/4 in nut head screws holding the ice maker
5 removed the ice maker and disconnected the power at the join
6 performed the above steps in reverse
7 the unit has since been producing ice
Repair appears to be a success

8 of 9 people found this instruction helpful.

Was this instruction helpful to you?

Customer:: Robert from WESTFORD, MA
Parts Used:: WP2220458
Difficulty Level:: Very Easy
Total Repair Time:: Less than 15 mins
Tools:: Screw drivers

Ice crusher not dispensing crushing ice or dispensing ice cubes

1. Remove the ice box
2. Unscrew the two Phillips screws on the base of the ice box compartment
3. Lift up the coupling and shaft (be careful because there is a spring between shaft and coupling and washer)
4. Remove old coupling
5. Replace with new coupling and remember to put back the spring
6. Insert back shaft with coupling and washer
7. Screw back on the Phillips screws
8. Replace back the icebox

7 of 7 people found this instruction helpful.

Was this instruction helpful to you?

Customer:: Michael from East Meadow, NY
Parts Used:: W11384469
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins
Tools:: Screw drivers

light not working in fridge

It was so easy!

Thanks for the rush to my home on the part.

I just unscrewed the plate that locks in the light switch (screwdriver) and unplugged the old faulty part and plugged in the new switch, screwed the cover back on and I was done!

Easy!

And I am not Mr. Fix-it!

7 of 8 people found this instruction helpful.

Was this instruction helpful to you?

Customer:: Janet from DOVER, DE
Parts Used:: W10873791
Difficulty Level:: Very Easy
Total Repair Time:: 15 - 30 mins
Tools:: Nutdriver, Screw drivers

Not making ice

1 Remove ice tray
2 turn off ice maker
3 Remove 4 screws
holding on the
cover over the ice
maker
4 remove the two hex
screws holding in
the ice maker.
Remove ice maker.
5 Reverse this procedure for installation.

6 of 7 people found this instruction helpful.

Was this instruction helpful to you?

Customer:: Antonio from San Antonio, TX
Parts Used:: W11384469
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins
Tools:: Screw drivers

All three lights are not working...lights are off but refrigerator still cooling. Also, the control box not lit up to show the temparture for freezer and refrigerator

Used a screw driver to pull old switch. Pulled one wire at a time, only two wires. After wires instlled to new switch push new one back in place where the old one was.

7 of 10 people found this instruction helpful.

Was this instruction helpful to you?

Customer:: Tom from LONGMONT, CO
Parts Used:: W10311524
Difficulty Level:: Very Easy
Total Repair Time:: Less than 15 mins

Changed air filter

Very simple, easy, and quick! Anybody can do it!!

6 of 7 people found this instruction helpful.

Was this instruction helpful to you?

Customer:: Duncan from Metairie, LA
Parts Used:: W11384469
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins
Tools:: Screw drivers

The Switch Broke...Absolutely Fell Apart.

I simply removed the old switch using 2 small screwdrivers and the old switch case popped out. I then upluged the wires from the old switch and reversed the process. Didn't take longer than 5 minutes begining to end! Thank you for the great service! Duncan quaid

5 of 5 people found this instruction helpful.

Was this instruction helpful to you?

Customer:: Stephen from Jacksonville, FL
Parts Used:: W10316760
Difficulty Level:: A Bit Difficult
Total Repair Time:: More than 2 hours
Tools:: Nutdriver, Screw drivers

Lower Freezer worked fine, but upper refrigerator would not cool.

I first replaced the lower (freezer) evaporator thermistor based on recommendation from other feedback, however that did nothing to resolve the problem. I subsequently discovered a diagnostic document hidden under the upper right door hinge, which helped me narrow the problem down to the upper (refrigerator) evaporator fan motor. After replacing the fan motor, my refrigerator is up and running again. The only challenge was accessing and removing the access panel(s) and air column. Once those were removed, replacing the fan motor was simple.

5 of 5 people found this instruction helpful.

Was this instruction helpful to you?

Customer:: Hans from OGDEN, UT
Parts Used:: WPW10475495
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins
Tools:: Socket set

Raise side of fridge and slide 2x4 under side with broken wheel.

Remove back side cardboard access cover. About 6 dcrews need to be removed. Remove 9/16” bolt and lower compressor tray frame down to slide out wheel axel. Place wheel in slot and replace axel. Lift compressor tray and replace 9/16” bolt. Replace cardboard cover. Remove 2x4.

5 of 6 people found this instruction helpful.

Was this instruction helpful to you?

Customer:: David from Dublin, NH
Parts Used:: W10311524
Difficulty Level:: Very Easy
Total Repair Time:: Less than 15 mins

air filter needed replacement

pulled the top shelf and poped open the door and replaced the filter

5 of 6 people found this instruction helpful.

Was this instruction helpful to you?

Customer:: David from GOWANDA, NY
Parts Used:: W11087200
Difficulty Level:: Easy
Total Repair Time:: 15 - 30 mins
Tools:: Nutdriver, Screw drivers

POWER SURGE TOOK OUT THE POWER INVERTER

ONCE WE KNEW THE COMPRESSOR WAS NO LONGER FUNCTIONING , USED A MULTI METER TO VERIFY 120 VOLTAGE TO THE INVERTER WAS PRESENT, FOUND 120 VOLTAGE TO THE INVERTER WITH NO VOLTAGE TO THE COMPRESSOR. OHMS OUT THE COMPRESSOR, FOUND IT WAS WITH IN SPECS. REPLACED THE INVERTER AND ALL IS WELL ONCE AGAIN.

6 of 9 people found this instruction helpful.

Was this instruction helpful to you?

Customer:: Thomas from HARPER, TX
Parts Used:: W10873791
Difficulty Level:: Easy
Total Repair Time:: 15 - 30 mins
Tools:: Socket set

Ice maker quick working and made a clicking sound while trying to drop ice

Removed freezer cover from ice maker, unplugged the harness. Installed the new ice maker assembly,plugged in two wire harness and secured the part and cover.
Results was smooth process, no noice from ice dispenser. Pleased with results. Saved on repairs. Thanks Tom

5 of 6 people found this instruction helpful.

Was this instruction helpful to you?

Customer:: Dave from Manchester Center, VT
Parts Used:: W11384469
Difficulty Level:: Easy
Total Repair Time:: 15 - 30 mins
Tools:: Nutdriver, Socket set

Refrigerator light would not stay on

Removed the 2 screws holding the light bulb shield, then the 4 uolding the metal panel. Unplugged the olw door switch and replaced.
reassembled the pieces.

4 of 4 people found this instruction helpful.

Was this instruction helpful to you?

Customer:: Orlando from Bayonne, NJ
Parts Used:: WP2300868
Difficulty Level:: Very Easy
Total Repair Time:: Less than 15 mins

Old one leaks on one side

Simply cut the water tube on both sides of connector and push in the new one.

4 of 5 people found this instruction helpful.

Was this instruction helpful to you?

All Instructions for the 10651779510