56957089791 Kenmore Refrigerator - Parts

This icemaker water inlet cup is three inches long. It is all white in color and is made of plastic.

This refrigerator kick plate grill is sold individually. Order two if you need to replace both clips. *Please note, if you are ordering the kick plate, check with your model number as these parts may be included.

This part is also known as the cycling thermostat and this bi-metal device controls the activation of the icemaker ejection cycle.

This is a compression nut for your refrigerator/freezer. The compression nut is used with the plastic water line for the icemaker assembly. It is the connection between the water supply line and the o...

This part is both the start relay and the overload. The start relay boosts the compressor, and then shuts off as soon as the motor gets up to speed and the overload provides extra protection against e...

White in color.

This crushed ice bucket is nineteen inches long and fourteen inches wide. It is all white in color and is made of plastic.

This evaporator fan motor is located in the back of the freezer, and circulates air over the refrigerator coils. These coils will convert the heat into cool air, which is then circulated.

Note: This part has been updated by the manufacturer. It may differ in appearance but will still function the same as the original.

1/4" Plastic tubing, 8 1/2 feet long.

This part strips ice from the icemaker mold during the ejection cycle to prevent ice pieces from falling back into the mold.

This screw is a little under an inch long and is made of metal. It is used with a refrigerator's ice maker assembly. Sold individually.