11026952692 Kenmore Refrigerator - Parts

This part includes 2 shelf support studs.

This part may come with a plastic or metal auger depending on the factory. It will work with your appliance if found with the model number. (Make sure you install properly at back of ice container, be...

This clip is sold individually.

This high pressure inlet hose washer is black. It is an inch in diameter, made of rubber, and used with many washing machines, refrigerators, and dishwashers.

This dispenser door pin comes with the washer.

Support wheel assembly with bracket. Kit of 2.

The heater is located at the bottom of the evaporator. The defrost heater heats the evaporator in the defrost mode of operation. The thermostat must be replaced when replacing the defrost heater.

This door gasket is used to seal the refrigerator door when closed to keep the cool air inside and the room air out.

16ml

This is a decorative front cover that is made of plastic that covers the opening to where the icemaker is located and disables contact by the user while the icemaker is engaged.

Once a glass is pressed against the actuator pad it will cause the dispenser to deliver water when activated.