CSK22ZADAAA Hotpoint Refrigerator - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Richard from New Boston, MI
- Parts Used:
- WR13X10020
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Nutdriver, Screw drivers, Socket set
Hinge cam on bottom of door broke
Watched PartSelect video and did exactly as video said. Had finished product in less than 30 minutes.6 bolts and one screw.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Connie from Woodstock, GA
- Parts Used:
- WR13X10020
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Nutdriver, Pliers, Screw drivers, Wrench (Adjustable)
Freezer side door would not close
Followed the video to replace bottom hinge assembly. The only hiccup was that the video instruction was for the fridge side door, so there wasn't step by step instruction for dealing with the electrical connection at the top of door or the water line at the bottom. However, it was simple enough to figure out. Replacement took about 20-25 mins.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Kathy from Andalusia, AL
- Parts Used:
- WR13X10020
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Nutdriver
Bottom Door Hinge Worn Out
Removed top hinge, lifted door from bottom post. Removed post with nut driver/socket, removed corresponding bracket/receiver from door. Attached new parts to refrigerator base and bottom edge of door. Was careful to replace part pieces in the same order as original, and secured tightly. Lifted door onto bottom hinge post, leveled the door and replaced top hinge.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Ken from Lexington, MO
- Parts Used:
- WR13X10020
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Nutdriver, Screw drivers, Socket set
freezer door would drop when opened bottom cam assy broken
shimed the door up to its proper level. removed plastic cam from bottom of door with a socket disconnected the water line fitting and clamp. with a nut driver removed the hinge assy from cabinet being careful i sled the hinge assy off the plastic water line being sure not to kink the line, sled the new hinge assy back on the water line and mounted the new hinge assy to the cabinet and connected the water line back up and turned on the water and checked for leaks, all went well. place the bottom grill cover back on.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Fin from Manning, SC
- Parts Used:
- WR13X10020
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Nutdriver, Screw drivers
door would not close properly
Followed directions in your video. Very helpful. Be certain to pay strict attention to how old part is removed. Had a little trouble replacing door on lower pin/hinge. Helps to have a little assistance. Good suggestion from another customer: get the kit.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- hugh from grand prairie, TX
- Parts Used:
- WR13X10020, WR02X10140
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Nutdriver, Screw drivers
bad hinge
like the video showed!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Barbara from Apache Junction, AZ
- Parts Used:
- WR13X10020
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers, Wrench set
lower hinge broken
removed door, replaced hinge, replaced door.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Holland from Raleigh, NC
- Parts Used:
- WR13X10020
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers, Socket set
The refrigerator door had to be pushed close.
I watched the repair video. Replaced the cam on the bottom of the door and the hinge pin. Now the door closes on its own, just like brand new.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Kevin from Aguanga, CA
- Parts Used:
- WR13X10020
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Socket set
door closer cam broke
replace the lower door hinge assy. and closer cam as a set.Only used a 1/4" socket and ratchet.The process was very easy without any problems.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Emil J from Pocono Lake, PA
- Parts Used:
- WR02X10140
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Refrigerator door would not close completely unless we pushed it all the way closed.
The Hinge Cam Riser came as ordered and arrived in 1 day! The original riser was clearly broken in half. After installing the new one on the door hinge and adjusting it several times, the door closed a little but still didn't close all the way. Finally, I re-installed all the door trays and filled them with the usual perishables, and the door closed perfectly! Apparently, the extra weigh on the door was needed to complete the job.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Larry from Ogden, UT
- Parts Used:
- WR13X10020
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Nutdriver, Screw drivers
Broken Cam on Bottom of Freezer Door
Removed door with little or no difficulty. Only time consuming portion of repair was disconnection and reconnecting of water line to door. This difficulty was primary due to age of the unit. After repairing, I determined that the cam on the refrigerator was also damaged so ordered same part to replace the refrigerator side.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Brenda from Colleyville, TX
- Parts Used:
- WR13X10020
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers, Socket set
Door would not stay closed
This was a Mother/Daughter feat. We viewed the video based on the bottom hinge assembly part that we had ordered. We did it exactly as shown and it was so easy. But while we had the door off we also had a chance to really clean the frigerator inside out. We were extremely happy that we were able to repair the frigerator oursleves and how much money we had saved by doing it. Thanks
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Daniel from Cherry Hill, NJ
- Parts Used:
- WR13X10020
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Nutdriver, Screw drivers
Door would not close.
With my wife's help, we emptied the door shelves and removed the door to the kitchen table. The video and instructions for replacing the parts were 100% right. We probably spent more time cleaning the door bottom and gasket than actually changing the hinge assembly! The job went very smoothly and saved us from overspending on a repair to this old fridge, or worse, making a quick decision on buying a new one.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- GEORGE from BAYONET POINT, FL
- Parts Used:
- WR13X10020
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers, Socket set
Existing Hinge And Washer Worn Out..
I watched your video on the repair twice and then did the repair. . . Your video was a major help and the only reason I decided to do the repair myself. . . The video was excellent and gave m e info on every detail of the repair. . . . . Thanks
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- James from Valdosta, GA
- Parts Used:
- WR13X10020
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers, Socket set
Refrig door did not have a stop point when opened
Repair was exactly as described on U-Tube video. The whole process, including removing items stored on the refrig door, took around 20 minutes and involved only a screwdriver and one socket. Could not have been much easier. Dont know why I delayed fixing what had been a long term annoyance.
Was this instruction helpful to you?
Thank you for voting!