EF42BNDBSS Hardwick Refrigerator - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Marilyn from Rancho Mirage, CA
- Parts Used:
- EDR7D1
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
annual replacement
have always done it myself, but Maytag store closed, so I didn't know where to purchase filter
I received it from Parts Select, in 2 days and if I remember right, price was cheaper than I paid last year, at store.
I received it from Parts Select, in 2 days and if I remember right, price was cheaper than I paid last year, at store.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Virginia from Belfast, ME
- Parts Used:
- EDR7D1
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
water filter expired
My husband did the replacement of the filter, so it was really easy for me. Easy for him too! The best part was this company had the best price, and the part was here in no time!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Daniel from Orleans, MA
- Parts Used:
- WP628356
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Broken ice maker arm mount
Pried out ice blade bar and removed broken water fill cup and replaced with new one.The whole repair costs $9.52 So I saved $ 190 over the cost of Appliance man visit!
It would have been $150& $50 for visit to replace ice maker unit.
It would have been $150& $50 for visit to replace ice maker unit.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Patrick from Davis Junction, IL
- Parts Used:
- EDR7D1
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Unclean Water Problem
Removed old filter with a twist and installed new filter the same way. Very simple task.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Al from Rio Rancho, NM
- Parts Used:
- EDR7D1
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Filter was one year old and needed to be replaced
Open refridgerator door, remove old filter by hand in a counterclockwise direction. Insert new filter turning clockwise. Close refridgerator door and fill a glass with water from dispenser. This will remove air and ensure water to free flow. Check for leaks.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Marlene from Baltimore, MD
- Parts Used:
- EDR4RXD1
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Indicator light showed Water Filter needed to be replace
Dropped down the housing for the water filter, twisted, removed item and slotted in the new filter. Easy as pie.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Pandora from North Ridgeville, OH
- Parts Used:
- EDR7D1
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Water Filter Replacement
Just a filter replacement -- however more impressed with the speed of which I could receive the replacement.
Can't find them anywhere local -- glad I found Part Perfect!
Can't find them anywhere local -- glad I found Part Perfect!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Charles from Newaygo, MI
- Parts Used:
- EDR4RXD1
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
no problem
took old one out installed new turn left out turn right in
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Jason from Draper, UT
- Parts Used:
- WP2182124
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Pliers, Screw drivers
Ice Stripper was broke off, leaving the mounting tabs still inside their respected spaces in the ice-maker
Had to remove the ice-maker (also easier than trying to work inside the freezer letting all the cold air out). A few mounting screws and an electrical connection in the back. After it was out you will need to remove the cover (not the superficial cover that just pries off) where the gear is behind it, just far enough so you can get the mounting tabs on the ice-stripper in. In order to to move this cover out, after removing the screws (the obvious), you'll need needle nose pliers to ever so slightly squeeze the plastic clips together that hold the plastic movable bracket and the metal ice level arm/switch, so it will pop out. Once you have room to put the ice stripper in, it should just all snap back together, then proceed in reverse to put it all back together.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Leonard W from Roseburg, OR
- Parts Used:
- WP628356
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers
Had to completely remove the ice maker in order to install the replacement part
Sorry for delay in writing. Part I ordered arrived two days ago and it was exactly what I needed. Knowing that there will be problems even with the smallest job I procrastinated starting. When I did start this morning I foud I had to completely remove the ice maker and disassemble it in order to install the water fill cup bracket. The challenge was reassembling the unit. Not hard for an experienced repairman but a challenge for layman. Everything is thing is back to gether now and power on cooling down the refrigerator. Won't know how successful it was until turn on water and ice is formed. If it works this saved $75 just to get a Sears repairman to come out and tell me what would be needed to fix the refrigerator and $1,000 if I had to buy a new refrigerator. Extremely satisfied with service I received. Thank you.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Yvonne from Worthington, IA
- Parts Used:
- WP628356
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Pliers, Screw drivers
Part Where Ice Maker Arm Fit In Broke Off
Took ice maker out all together we removed 4 to 5 screws had to remove axel to get the broken piece out and new one in my husband said it was easy in and out in about 15 minutes saved about 150. 00 Thanks partslect
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Joyce from Springfield, MO
- Parts Used:
- WP627843
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Nutdriver, Screw drivers
Ordered ejector arm.
No instructions with part. Found a picture on line and changed the arm, but it didn't fix the problem. Fairly easy after figured out what needed to be done to get to the part.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- David from Ceres, CA
- Parts Used:
- W10156818
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Nutdriver
broken fan blade
unplug refrigerator, take backing off with nut driver. Pull old blade off and put new blade on. Put backing back on and plug in.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- augustine from cedar rapids, IA
- Parts Used:
- WP628356
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Nutdriver, Screw drivers, Socket set
broken water fill cup
empty frezzer take door off unplug wires going to ice maker unscrew/bolt icemaker replace door take motor cover off ice maker remove screws on motor replace ice cup and put every thing back together
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- David from Portland, OR
- Parts Used:
- EDR4RXD1
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 15 - 30 mins
Replaced ice & Water filter, but message on refigerator still shows "Replace Filter"
As per instructions to replace filter
Was this instruction helpful to you?
Thank you for voting!