Models > GRS22PRBD0 > Instructions

GRS22PRBD0 Gibson Refrigerator - Instructions

Jump to:

All Instructions for the GRS22PRBD0
121 - 135 of 261
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
LUIS from CENTENNIAL, CO
Parts Used:
215846602
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
Freezer built ice, fridge not cold enough and running constantly.
Removed front low grill, removed the two screws that hold the element in place. I then pulled the element out about 3 inches and disconnected the wires. Reversed process to install new timer.
1 of 4 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
LK from LAWRENCE, KS
Parts Used:
5303289501
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
broken rail inserts that hold the drawer up and in place
Moved glass front from broken drawer and placed on new drawer
0 of 1 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Dan from Lakewood, CO
Parts Used:
5303289500
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
drawer had broken side rails
I removed old drawer. Then I removed the front face panel. I had to wedge the knife in the front bottom so I could remove the face. Installed face on new drawer. Inserted new drawer in fridge.
Voila ! Works great.
0 of 1 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Michael from Tampa, FL
Parts Used:
5303289501, 5303289500
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Drawers had broken due to age
Founds parts I needed here. Customer service was very helpful. Parts arrived in very short time frame 1-4 days.
0 of 1 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Elizabeth from Weems, VA
Parts Used:
215267701
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Wrong size listed on website.
The end cap is easy to remove and replace. The personnel at PartSelect was extremely helpful in re-ordering the correct part.
0 of 1 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Joachim from Marengo, AL
Parts Used:
5303289501
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
refr. shelf had been damaged and glueing would not work permanently
Just snap the ordered part to the undamaged front part together.
0 of 1 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Lee Ann from Houston, TX
Parts Used:
5303289500
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
broken drawer
removed the drawer, pried off the glass front, slid the glass front into the new drawer, and returned the drawer to its place in the referigerator.

The schematic drawings on the PartSelect website were really helpful.
0 of 1 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Thomas from Williamstown, NJ
Parts Used:
5303289501
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
The Drawer was broken on the guide edge.
Got the new one and took the face plate off the old and sliped it right on to the new one. I noticed that the guide edges on the new Drawer are made better. That is added bennie.

Thank you so much
0 of 1 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Marcus from Pine Hill, AL
Parts Used:
215846602
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
frezzer iceing over and not cooling the refrigerator
Just removed the two screws and unpluged it.
Then I pluged the new one in and replaced the screws. It runs like a brand new reffrigerator.
Thanks for the fast delevery. Will do busness with you in the future.
1 of 4 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
brad from minneapolis, MN
Parts Used:
5303917954, 215846602
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Screw drivers
Freezer okay, but fridge was warm
Website was great!

The defrost timer was right in front. 2 minutes and a screwdriver and I had it replaced.

To replace the thermostat, I had to take out the back panel, defrost it and then install the new part. the only problem was that the heatshrink tubing they sent was too large. Otherwise, it worked great.
0 of 1 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Jeff from Willoughby, OH
Parts Used:
5303289500
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Broken storage drawer
First I removed the old drawer front. When put the old front onto the new drawer I noticed that the two little rubber plugs had nowhere to push into as the holes were not drilled out. I got my portable drill and drilled out the holes, then I slid the drawer front into place snapped it in and pushed in the plugs.
0 of 1 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
steve from Kirkland, WA
Parts Used:
215846602
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
freezer worked frig was warm. Ice maker is still not working
Removed two screws to get to defrost time pull panel down remove two screws holding time and reinstall
0 of 1 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Ronald from Defiance, OH
Parts Used:
215846602
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Screw drivers
leaking water down into fridge
just like the video showed...it was excellent!!!
0 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Thomas from Stuart, FL
Parts Used:
215846602
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Screw drivers
coil Iceing up
took 4 screws out of the discharge vent on top of the refrigerator section and unpluged the wiring harness and put the section on the counter and unscrewed the timer and put the new one in and reinstalled the assembly and plugged the Jack and put the 4 screws back in, and rotated the timer and put it on defrost removed the back and check the heaters and drain .
0 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
James from Lake Havasu City, AZ
Parts Used:
5303289501, 5303289500
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
Drawers are cheaply made and woreout quickly
The job was as simple as could be pry away the old and push in the new.
Only wish I had done years ago. Tthis is a great service to customers.
0 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the GRS22PRBD0
121 - 135 of 261