GRS22PRAD0 Gibson Refrigerator - Instructions

No tools required! Easy as falling off a log! Drawer face snaps off and reinstalls on new drawer body; slide it in track and you're good to go.

Pulled out the drawer and replaced it with the new one.

I took my time to remove the front off of the old drawer,by gently prying it apart with two screwdrivers, this was the hardest part, the front installed very easily . The shippiong time was 2 days instead of three. Will use partselect again.

Use small srew driver to take door off and put back on just like the video you supplied on line.

We removed the front of the drawer from the old drawer and reinstalled on replacement drawer. It only took about 5 min. to complete. Shipping was Prompt. The person that helped to establish the Part no. was very helpful.

took door off. sanded rusting hinge and greased. installed door hinge washer. I had to install a larger washer over hinge bearing to help support the door where it was rusting. no sweat. works like its new. thanks to you guys for having the parts.

I didn't know the front of the drawer could come off so it was pretty gunked up with dried meat juices that had leaked. The fit was very tight. I had to really work the putty knife to get it between the front and the drawer at the bottom where the catch is. I was afraid I would break or chip the front before I got it off but it handled the pressure pretty well. Had to use some force though. Once I cleaned the front it slid right down and snapped into place.

The job was as simple as could be pry away the old and push in the new.
Only wish I had done years ago. Tthis is a great service to customers.

Ordered the parts from the product discription (photo) as well as chart showing actual size. Got the parts( in two separate shipments) cut the bar to length and snapped them inot place. Bingo!

just like the video showed...it was excellent!!!

took 4 screws out of the discharge vent on top of the refrigerator section and unpluged the wiring harness and put the section on the counter and unscrewed the timer and put the new one in and reinstalled the assembly and plugged the Jack and put the 4 screws back in, and rotated the timer and put it on defrost removed the back and check the heaters and drain .

The instructions given to me by part Select were very good.I replaced the Timer- checked the heater with oham meter it was good- checked the door weather striping it was good and replaced the thermostat with new .So at this point I may need to call a professional unless some one has another solution.

first I replaced the timer control hoping thats the problem,unfortunately situation the same ice build up on the freezer.so I replaced the defrost thermostat.right now I'll still observing the condition if still the same.may be in couple days.so far its good.and to replace the parts is not difficult and easy.

The replacement of the Drawer Cover support was simple, it snapped in to the existing holes. You had said you did not have a replacement for the crisper drawer cover but the storage drawer cover was identical and I ordered it, and snapped the adjustable vent off of the old crisper onto the new storage drawer cover and all was well. The parts arrived in two days without expedited shipping. I couldn't be happier.

bottom left cornerof fridge defrost timer replaced two bolts and a wire