TBX14SABNRAA General Electric Refrigerator - Instructions

Separately (from a different site) purchased new compressor fan and motor. I purchased the grommets here because the other site listed the grommets as temporarily out of stock. I did watch one of the videos on PartSelect about the grommet replacement. Repair was pretty simple, biggest challenge was getting to the screw on the far side of the motor. Removed the two screws holding the fan motor into place. Removed motor and blade. Reinstalled with new fan blade, new grommet and new motor.

Unplugged the refrigerator then used the cordless drill to remove the 6 screws on the access panel on the back of the fridge to be able to get to the fan. Was able to pull the fan off by hand and push the new fan on by hand. Plugged the refrigerator by in and watched the fan run for a few minutes then replaced the access panel. Really quick and easy repair.

I disconnected the old defrost heater removing 2 small screws and the electrical connectors, afterward I attached the new part, reconnecting back the electrical connectors and screwing the removed 2 screws.

I didn’t do the repair because I ordered two grommets. When they arrived, one of the packages was empty! Instead of just sending me another one, they refunded the part so I still need one. By the way, I was not refunded half the shipping either which was more than the part itself.

Easy

First I had to order the part. The part arrived quickly, but without mounting hardware or instructions. It was easy enough to determine the placement of the shelf, but had to locate mounting screws from the hardware store, drill two holes, secure the shelf.

Took out vegetable draws, removed old cover and put in new vegetable pan cover. Then put back drawers.

I lifted old one out and place new one in

I pulled out the old one and slid in the new one. Doesn't get any easier, but I have learned for future reference that beer in the crisper equals cracked vegetable pan.

Removed the drawers.Took out old cover by tilting up,Put New cover back on Tilting again to set it in ,brought it down on its rests and replaced the drawers.

I removed the old shelf and even though the new one had a slightly different texture, it fit perfectly and the two crisper drawers slid right in.

it was slowing cracking for a long time, and repairs with duct tape and crazy glue were a futile attempt to avoid the inevitable; a new part altogether! Well a few moments searching your site for the exact piece were all that was needed. With 48 hours of placing the order I had it in my apartment and just slipped it into place! it was a piece of cake!Thank you so much!

All I had to do was remove what I had on the shelf, remove the bins, replace the shelf and slide the bins back in, replace what I had on the shelf and close the door. I am so happy now when I open the refrigerator door and the new (unbroken) shelf has replaced that old broken one.

ordered the part and installed without any tools. The order also arrived in a day or two which was surprising.
I will use this service again if needed for parts. The service was great!

I simply removed the old cover and replaced it with the new one! Fit was perfect. Thanks!