Models > TBX21DKGR > Instructions

TBX21DKGR General Electric Refrigerator - Instructions

Jump to:

All Instructions for the TBX21DKGR
91 - 105 of 122
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
paul from east hanover, NJ
Parts Used:
WR23X37285
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Pliers, Screw drivers
refig light did not work
per your instructions
Was this instruction helpful to you?
Thank you for voting!
Customer:
Kevin from Morris, IL
Parts Used:
WR55X24065
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver
Compressor not coming on
Had to e-mail GE for electrical schematic. Checked voltages to compressor. Jumpered compressor to see if it would even come on. Found bad run capacitor. Fixed.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Country at from SAYRE, OK
Parts Used:
WR55X24065
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Pliers, Screw drivers
A power surge made my side by side refrigerator stop working
I started at the compressor and replaced the overload and the Ptcr first and that did not make the compressor start running again, so I replaced the capasitor and it still did not start, so I bit the bulett and replaced the Main Control Board and that is what I should have checked first, when I removed the old one I found a little burnt spot on the back that I could not see from the front. The new one did not look exactly like the old one, it had two more wire terminals than the old one, but just leave them blank and everything will work just fine!
Was this instruction helpful to you?
Thank you for voting!
Customer:
Paul from Irving, TX
Parts Used:
WR07X26748
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
all power to refrigerator quit
layed fridge face first on a chair removed cover with flat head screwdriver unplugged part replaced with new part replaced cover returned to upright and plugged in
Was this instruction helpful to you?
Thank you for voting!
Customer:
Roger from Eldridge, IA
Parts Used:
WR2X8345
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Broken end cap
Just snapped in the replacement. 15 second repair. I was not completely sure that I had the right one ordered. There were two choices. I selected one and it worked fine.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Dennis from Flower Mound, TX
Parts Used:
WR72X273
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
Plastic Drawer Slide Rail was broken
I was a bit concerned that I might have selected the wrong part. There were several pictures of rails to choose from with slight variations on the website. Fortunately, it was a correct selection and arrived sooner than expected. The assembly was easy to remove from the refigerator. Two screws that held the slide in place were removed and the replacement was installed within minutes. I am very pleased that I chose to use PartSelect.
Was this instruction helpful to you?
Thank you for voting!
Customer:
ANTHONY from NEW EGYPT, NJ
Parts Used:
WR23X37285
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers, Screw drivers
sticky switch
easy pry out, disconnect wiring, connect on new switch and press in switch.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Marilyn from Flowood, MS
Parts Used:
WR71X10715
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
needed an extra shelf
Part was received quickly and quickly installed-Thank you
Was this instruction helpful to you?
Thank you for voting!
Customer:
Cynthia from Seatac, WA
Parts Used:
WR23X37285
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
switch wouldn't come out anymore and turn light on
Gently pry out switch in door jam with screwdriver and pull both connectors off and put connectors on new switch then push switch back into the hole. Looked it up on the internet and video showed how to and also had link to new part, ordered and less than a week later the fridge is bright again. I have an older freezer also and it seems that they all use the same switches. Very Very easy
Was this instruction helpful to you?
Thank you for voting!
Customer:
huey from covington, LA
Parts Used:
WR2X8345
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
broken endcap
just pop it together
Was this instruction helpful to you?
Thank you for voting!
Customer:
Donald from North Chesterfield, VA
Parts Used:
WR72X273
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Right side rail of meat drawer cracked
Less than 5 minutes needed to remove cracked rail and replace with new rail. Must have a star wrench to perform task. Very simple task!
Was this instruction helpful to you?
Thank you for voting!
Customer:
Gerald from Brunswick, OH
Parts Used:
WR2X8345
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Borken end caps on freezer door retainer
Took the broken ones off, placed the bar on the end caps and snapped them into the freezer door.
Was this instruction helpful to you?
Thank you for voting!
Customer:
David from Simpsonville, SC
Parts Used:
WR23X37285
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
light switch quit working
removed the inside fridge electrical panel and swapped switches
Was this instruction helpful to you?
Thank you for voting!
Customer:
Jules from Crowley, LA
Parts Used:
WR23X37285
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers, Screw drivers
failed light switch
I started removing the switch by prying on the right side with a screwdriver, when it emerged enough I used pliers to finish removing it. I then unpluged rhe wires from the bad switch and pluged them on the new switch and "poped" it into the hole.
Was this instruction helpful to you?
Thank you for voting!
Customer:
christopher from collegeville, PA
Parts Used:
WR23X37285
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
no light in freezer
Connected the 2 wires and pushed in the switch until it clicked.
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the TBX21DKGR
91 - 105 of 122