33346-1 General Electric Refrigerator - Parts

This rear crisper support mounts on the inside of the refrigerator wall to support the rear crisper cover. It is made of white plastic and is sold as an individual part. The support is secured in plac...

The door shelf bin, sometimes referred to as a 2-liter bin, measures approximately 15 inches wide by 6 inches high and 6 inches deep. It is a genuine OEM replacement part that is made of white plastic...

This is a genuine OEM ice maker assembly for your refrigerator. The ice maker makes eight cubes at a time, by filling the mold with water from the inlet valve, freezing the water until the cubes are f...

Sold individually. This cam is located at the bottom of the fridge/freezer door.

This is a genuine OEM kit for the defrost thermostat in your freezer. This kit comes with the clip, leads, and heat shrink. Some indicators that you may need to replace your thermostat is if there is ...

This ice container assembly is a genuine OEM replacement part for your refrigerator. This kit includes the container that holds the ice, along with the auger and blades. Replacing this assembly is an ...

Once a glass is pressed against the actuator pad it will cause the dispenser to deliver ice or water when activated.

This kit includes the motor, clips and terminal connectors. This part has been updated by the manufacture. This evaporator fan motor is located in the back of the freezer, and circulates air over t...

This part is the replacement heat-release ice maker unit only. This kit comes with four round female connectors at the end of the wire harness. It also comes with the adaptor that converts the harnes...

This part may look different or be a different color than the original, but will fit and function the same as the original part.

This part helps push the ice through the front plate to be crushed.

Bucket only. All other parts sold separately.