All Installation Instructions for General Electric Refrigerator GTT15FBMBRWW

Customer:: paul from renfrew, PA
Parts Used:: WR60X31522
Difficulty Level:: Really Easy
Total Repair Time:: 15 - 30 mins
Tools:: Nutdriver, Screw drivers

motor makin load hum

Part came in a couple of days, very fast delivery. Read how other people installed. Only drawback was the youtube video was not available. Thanks again!

Was this instruction helpful to you?

Customer:: Stephen from Philadelphia, PA
Parts Used:: WR60X31522
Difficulty Level:: Easy
Total Repair Time:: 15 - 30 mins
Tools:: Nutdriver, Pliers, Screw drivers

Refridgerator was warm, Evaporator Fan was stuck

Followed the video by Parts select. Very accurate to remove and replace. The only trouble I ran into was getting the clip back onto the fan blade shaft! Have to improvise and use a wirenut to spread it and it went right onto the shaft. Now working perfectly! Thanks for the video and the fast part service shipping...

Was this instruction helpful to you?

Customer:: Carol from Black Canyon City, AZ
Parts Used:: WR60X31522
Difficulty Level:: Easy
Total Repair Time:: 15 - 30 mins
Tools:: Nutdriver, Pliers, Screw drivers

very noisy when running

I followed the video instructions and the job was done in no time at all

Was this instruction helpful to you?

Customer:: Bernard from Palmetto, FL
Parts Used:: WR60X31522
Difficulty Level:: Really Easy
Total Repair Time:: 15 - 30 mins
Tools:: Nutdriver, Pliers, Screw drivers

fan was hummingtoo

took of the metal plate four screws also the plastic cover two screws. then took the fan off two screws , then took the fan off the motor, remove the metal clip off the tip off fan

Was this instruction helpful to you?

Customer:: paul from east hanover, NJ
Parts Used:: WR23X37285
Difficulty Level:: Really Easy
Total Repair Time:: 15 - 30 mins
Tools:: Pliers, Screw drivers

refig light did not work

per your instructions

Was this instruction helpful to you?

Customer:: Richard from Zephryhills, FL
Parts Used:: WR60X46086, WR60X31522
Difficulty Level:: Really Easy
Total Repair Time:: 15 - 30 mins
Tools:: Screw drivers, Wrench set

intermittent vibrating noise in the freezer

emptied the freezer compartment, unfastened the air column panel, then four small bolts to remove the back panel in the freezer, unplugged the motor, unscrewed the motor, installed all in te reverse order and had the compartment refilled and running again in less than a half hour.

Was this instruction helpful to you?

Customer:: David from Barstow, CA
Parts Used:: WR60X31522
Difficulty Level:: Easy
Total Repair Time:: 15 - 30 mins
Tools:: Nutdriver, Screw drivers

fridge warm, no fan blowing air to fridge.

the hardest part for me was the fan blade clasp.still only took like 20 minutes.But the best part was, the part was delivered and fixed within 24 hours of buying online. Great service guy's, Thanks.

Was this instruction helpful to you?

Customer:: Donald from Denver, PA
Parts Used:: WR60X46086, WR60X31522, WR02X12008
Difficulty Level:: Easy
Total Repair Time:: 15 - 30 mins
Tools:: Nutdriver, Screw drivers

The fan motor started making noise

The is my 'refreshment' cooler and sits in our garage. Hotter than heck in the summer so the things runs a lot. Started making a little growling noise. Had to partially disassemble the back panel to get to the fan. Touched the exposed shaft for a second and the sound stopped. OK, it's the fan. Went on line, used the (really great) exploded diagram to figure out what I needed. A couple days later the parts show up. Installed the new fan blade and retainer Removed the old motor (couple of mounting screws), connected the new motor (a plug in) and mounted the new motor making sure the grommet on the front and back were engaged. Turned the unit on and everything worked. Reinstalled the foam channel, the back panel and it ran perfectly. Great support (the diagram), fast delivery and fair pricing. Not bad!

Was this instruction helpful to you?

Customer:: Dale from Williamsburg, OH
Parts Used:: WR60X31522
Difficulty Level:: Really Easy
Total Repair Time:: 30 - 60 mins
Tools:: Nutdriver, Pliers, Screw drivers

noisy motor shaft loose

I simply followed the online video instructions.made the job easy and fun.

Was this instruction helpful to you?

Customer:: Glenn from Lincoln, MI
Parts Used:: WR60X31522
Difficulty Level:: A Bit Difficult
Total Repair Time:: 30 - 60 mins
Tools:: Nutdriver, Pliers, Screw drivers

Loud noise from the freezer area during the defrost cycle

Removed all the freezer inside panels to inspect the motor before I ordered the part. It looked like a relatively easy job to change it. I also watched the really nice video on the website that re-inforced my confidence in doing the job. The part came in a few days. I disassembled the freezer interior exactly as the video showed.(Warning: be careful with the styrofoam piece if the fridge is not fully defrosted. The ice build-up could cause it to break when trying to pull it out!)The only problem I had was getting the little collar on and off the motor fan shaft, and getting the fan off the shaft. I had to pull really hard for it to come loose and then I had to push really hard to get it back on the new motor shaft. I didn't know if could have used any kind of lubricant or not, so I didn't. After that the re-assembly inside the freezer went well, being careful to put everything back in the correct order and position. Started the fridge back up and it has been running very quietly ever since. But, most important, my wife was impressed with my work and is very pleased with the result!

Was this instruction helpful to you?

Customer:: Kenneth from Trinity, TX
Parts Used:: WR60X31522, WR02X12008
Difficulty Level:: Easy
Total Repair Time:: 30 - 60 mins
Tools:: Nutdriver, Pliers, Screw drivers

Fan was making a VERY LOUD noise

First I looked at the video on changing out the fan.Made a lot of difference. Everything was covered and made it simple. Wish I had gotten two grommets but the back one was in good shape and worked fine. My hearing isn't great but now I can't even hear the thing run unless the freezer door is open. The shipping was great! You sent it out immediately and in a few days it was here.

Was this instruction helpful to you?

Customer:: christopher from collegeville, PA
Parts Used:: WR23X37285
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins

no light in freezer

Connected the 2 wires and pushed in the switch until it clicked.

Was this instruction helpful to you?

Customer:: Lonnie from Covington, LA
Parts Used:: WR71X10378
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins

added an additional shelf

just pushed it in ! THANKS FOR THE GOOD SERVICE

Was this instruction helpful to you?

Customer:: Jules from Crowley, LA
Parts Used:: WR23X37285
Difficulty Level:: Easy
Total Repair Time:: Less than 15 mins
Tools:: Pliers, Screw drivers

failed light switch

I started removing the switch by prying on the right side with a screwdriver, when it emerged enough I used pliers to finish removing it. I then unpluged rhe wires from the bad switch and pluged them on the new switch and "poped" it into the hole.

Was this instruction helpful to you?

Customer:: Jim from Sarasota, FL
Parts Used:: WR12X10108, WR12X10107
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins
Tools:: Screw drivers

The handles on my GE fridge had yellowed over 12 years use.

Just took the old ones off, the new ones went right on. Took less than 10 minutes. It`s nice to order parts and get the right ones on the first try.

Was this instruction helpful to you?

GTT15FBMBRWW General Electric Refrigerator - Instructions