GFSS6PKBASS General Electric Refrigerator - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- George from Washingtonville, NY
- Parts Used:
- WR32X10668, WR32X10667
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
broken door hinge pin
replaced door and window. Snapped in place
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- W Craig from Diamondhead, MS
- Parts Used:
- MWFP
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Filter needed replacing
Folowed instructions
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- donnie from metairie, LA
- Parts Used:
- MWFP
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
replaced filter
none required
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- david from bridge city, TX
- Parts Used:
- WR13X10516, WR02X12643
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
on the french doors my granddaughter kept turning the inner seal bar when the door was open and when we went to close it it was in the wrong position and eventually the upper hinge broke
I took a small straight screw driver and popped the cap case off, removed old hinge and installed new hinge and snapped the cap back in place.. took all of 30 seconds
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Sharol from Culdesac, ID
- Parts Used:
- WR02X12651
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Spring broke
Installed new spring pin and spring. Took only 2-3 minutes. It was more difficult to get the correct part since the spring pin was the only number listed in the part diagram and I actually needed the spring and had to call customer service to get the correct part number.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Michael from Lebanon, OH
- Parts Used:
- WR32X10668
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- Less than 15 mins
One of the pins holding the frame broke.
I had to remove the clear plastic from the old part and install it on the new frame. I put the plastic in first and could have easily broken a pin. There should be a recommendation to put the frame in when it can bend a little and reduce the chance of breakage again. Put the clear plastic piece back in after the frame is in. That would have been much easier.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Colby from Midlothian, TX
- Parts Used:
- WR32X10668
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Drawer was left open when doors were shut. Broke one of the pins that holds the drawer cover in place
Removed the clear plexiglass window. Cleaned it with soap and warm water preparing it to be installed into the new Drawer Cover Frame. Re-installed the Plexiglass into the new frame and mounted cover assembly to its fixing place.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Carole from Sunrise, FL
- Parts Used:
- WR32X10662
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
crack by the middle of vegi drwaer
easy slide out and put new one
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Robert from Arlington Heights, IL
- Parts Used:
- WR32X10666
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Broken pantry flip lid cover
1.) Remove produce drawers above deli drawer. (2). Place right side pin of deli drawer cover into hole. Note that hole on right side has a raised lip so you need to insert this side first. (3). Sprayed PAM cooking spray on deli drawer near hole on left side. (4). Slide left side pin on deli cover into hole on left side. 5 minute job, quite easy. Use cooking spray to lubricate the pin so you don't have to force it into hole on left side and risk breaking it.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Randell from Rancho Cucamonga, CA
- Parts Used:
- MWFP
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Filter needed replacing
Very easy, unscrew and re-screw new filter in..
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Jared from Sandy, UT
- Parts Used:
- WR72X10270
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Factory installed rail was overtightened and fractured the rail. Subsequent use resulted in rail failure.
Remove drawers and internal shelf supported by rail(no tools). Remove rail (phillips). Remove roller from existing rail. Intall roller on new rail. Install new rail (phillips). Replace shelf and drawers. Note: New roller (identified as a separate part) and screws are not included with rail.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Richard from La Grande, OR
- Parts Used:
- MWFP
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
water filter was aged and needed a replacement
unscrew filter and replace the new one
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Clarence M. from Roanoke, VA
- Parts Used:
- WR32X10666
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Side tab broke off
Very easy ,new unit has rollers instead of all plastic sides,just pop- it in, now works better than original.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Dan from Surprise, AZ
- Parts Used:
- MWFP
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
We needed a new water filter.
We received the part just a few days after ordering, unscrewed the old filter by hand, and installed the new filter the same way.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Natalia from Mount Pleasant, SC
- Parts Used:
- MWFP
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Water filter needed replacement
Removed the old filter. Filled the new one with water and put it in theplace of an old one. Flushed the system with 1 gallon of water.
Was this instruction helpful to you?
Thank you for voting!