PFSF6PKXDBB General Electric Refrigerator - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Catherine from SEATTLE, WA
- Parts Used:
- 40A15
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
The light inside the oven had burned out
0. As a safety precaution, unplug the range or hit the relevant fuse breaker before you start. You might also want to grab a flashlight. Definitely do not try to do this while the oven is hot.
1. Pinch the wire over the light bulb cap to remove it. This is inside the oven at the back.
2. Pop off the hemispherical glass cap.
3. Unscrew the old light bulb, and screw the new light bulb in its place.
4. Put the cap back.
5. Secure the cap by putting the wire back in its slots on the cap.
No tools needed, the cap is just held in place with pressure from the wire.
1. Pinch the wire over the light bulb cap to remove it. This is inside the oven at the back.
2. Pop off the hemispherical glass cap.
3. Unscrew the old light bulb, and screw the new light bulb in its place.
4. Put the cap back.
5. Secure the cap by putting the wire back in its slots on the cap.
No tools needed, the cap is just held in place with pressure from the wire.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Michael from NEWTON FALLS, OH
- Parts Used:
- WR60X10254
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 1- 2 hours
- Tools:
- Screw drivers
Fan not cooling top of refrigerator,
Took off the back inside fridge and found that part was frozen with ice and unthawed it took over night al was ok.
Ps turned refrigerator up to 40 degrees all is ok.
Did not put part in : thanks
Ps turned refrigerator up to 40 degrees all is ok.
Did not put part in : thanks
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- JOSEPH from CLIFTON PARK, NY
- Parts Used:
- WR30X10131
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Icemaker worked except for warming coil which prevented ice from releasing into tray
Replacement ice maker was plug in unit, only needed to remove one screw holding plastic plate that hid plug and wiring. Plugged it in and reattached plate with screw and done!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Terry from GRANADA HILLS, CA
- Parts Used:
- WR29X10097
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Ice dispenser
I took out the old one and put in the new. 15 seconds.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Gerald from WINTERVILLE, GA
- Parts Used:
- 40A15
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
lights blown out
replaced lights in refrigirator and freezer
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- James from DEFIANCE, OH
- Parts Used:
- WR30X10131
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Ice Maker stopped workiing
Hardest part of repair was getting frig. away from cabinets to unplug it.
Turn off water to ice maker.
Phillips's screwdriver to take off the cover of the electrical connection to
the icemaker tip it outward. I used flat head screwdriver to help disconnect the connection.
Also, to help getting the old icemaker removed. Once removed returned New one the reverse of taking it out. Won't need screwdriver to get it back in place. Put cover back in place and put the Phillips screw back in place. Plug refrig. back in. put it back in place turn the water back on should be good to go! BE afew hrs. before ice starts to show up!
Good Luck
Turn off water to ice maker.
Phillips's screwdriver to take off the cover of the electrical connection to
the icemaker tip it outward. I used flat head screwdriver to help disconnect the connection.
Also, to help getting the old icemaker removed. Once removed returned New one the reverse of taking it out. Won't need screwdriver to get it back in place. Put cover back in place and put the Phillips screw back in place. Plug refrig. back in. put it back in place turn the water back on should be good to go! BE afew hrs. before ice starts to show up!
Good Luck
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- John from CADILLAC, MI
- Parts Used:
- DA81-01345B
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Pliers
Broken spring on french door
Placed lower spring leg in hole first. Manipulated upper spring leg into upper hole with needle nose pliers.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Rose Marie from CONSHOHOCKEN, PA
- Parts Used:
- WR29X10097
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Ice Makes was cracked and part was broken off.
Took out the old piece. Washed and replaced with the new one.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Dale from MACUNGIE, PA
- Parts Used:
- DA81-01345B
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Broken mullion spring on left door
Placed one end of the new spring in left hole and used the needle nose pliers to insert the other end of the spring in the right hole.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Robert from Myrtle Beach, SC
- Parts Used:
- MWFP
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Yearly replacement of filter
Moved stuff out of my way on the top shelf, reached in and turned old filter to remove. Filled new filter with water, lined up and turned to lock in place. Whew, never thought I would get that job done. :-)
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Deryl from KINGWOOD, TX
- Parts Used:
- DA81-01345B
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Door would not close properly
Spent a dollar 1.97 on the spring.7.00 on shipping and fixed it in less than 5 minutes.Fantastic
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- David from NORTHWOOD, NH
- Parts Used:
- DA81-01345B
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Pliers
Just follow instructions. Easy
Held spring with needle nose pliers and slipped into place
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- susan from hartford, WI
- Parts Used:
- MWFP
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
Bad tasting ice cubes
Took the old filter out and put the new one in.
Easy Breezy!!
Easy Breezy!!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Joanne from Fort Smith, AR
- Parts Used:
- MWFP
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Auto water stopped working, found that filter needed replacement
Unscrewed old cartridge, ordered new cartridge, installed new cartridge by following very simple instructions. Took only one day for part to arrive from PartSelect although I paid for cheapest shipping, which was "ground." I was amazed!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- JAMES from MORENO VALLEY, CA
- Parts Used:
- MWFP
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Water dispensed at a trickle
I only had to remove the old filter and install the new one - all by hand. I then ran about 1 to 1and1/2 gallons of water through the filter to clear it.
A WORD OF CAUTION - HOLD YOUR GLASS CLOSE TO THE WATER DISPENSER FOR THE INITIAL FILLING - IT WILL SPIT UNTIL THE AIR IS PURGED FROM THE SYSTEM!!!
An extremely easy repair.
A WORD OF CAUTION - HOLD YOUR GLASS CLOSE TO THE WATER DISPENSER FOR THE INITIAL FILLING - IT WILL SPIT UNTIL THE AIR IS PURGED FROM THE SYSTEM!!!
An extremely easy repair.
Was this instruction helpful to you?
Thank you for voting!