PFSS6PKXCSS General Electric Refrigerator - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- DENISE from Simpsonville, SC
- Parts Used:
- WR32X10668
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Pin broke off of pantry cover frame
Appreciated others comments before I had to repair mine! Took me a bit to get clear part out of white frame (with screwdriver). Popped clear part into new white frame, but then had to push on some parts to really get it to snap fully in. Then it was simple to put the one pin into the hole on the fridge and bend the frame slightly for the other pin to go in. Thrilled to have it look great and work correctly.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Sharol from Culdesac, ID
- Parts Used:
- WR02X12651
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Spring broke
Installed new spring pin and spring. Took only 2-3 minutes. It was more difficult to get the correct part since the spring pin was the only number listed in the part diagram and I actually needed the spring and had to call customer service to get the correct part number.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Jared from Sandy, UT
- Parts Used:
- WR72X10270
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Factory installed rail was overtightened and fractured the rail. Subsequent use resulted in rail failure.
Remove drawers and internal shelf supported by rail(no tools). Remove rail (phillips). Remove roller from existing rail. Intall roller on new rail. Install new rail (phillips). Replace shelf and drawers. Note: New roller (identified as a separate part) and screws are not included with rail.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Richard from La Grande, OR
- Parts Used:
- MWFP
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
water filter was aged and needed a replacement
unscrew filter and replace the new one
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Clarence M. from Roanoke, VA
- Parts Used:
- WR32X10666
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Side tab broke off
Very easy ,new unit has rollers instead of all plastic sides,just pop- it in, now works better than original.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Richard from Waynesboro, PA
- Parts Used:
- MWFP
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
replace water filter
Easy, with included video and instructions
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- GREGORY from SACRAMENTO, CA
- Parts Used:
- MWFP
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Change Filter
My 14 year old Son
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Irene from Tigard, OR
- Parts Used:
- MWFP
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Ice and Water Filter needed replacement
It was easy and fast, like changing a light bulb. The directions were clear and easy to follow. Thank you.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- terry from fort worth, TX
- Parts Used:
- MWFP
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
did not need adapter
exactly as the instructions.......never did see anything about replacing the adapter...therefore i did not
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- James from RSM, CA
- Parts Used:
- WR30X10131
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Ice Maker assembly was leaking into cube tray and fusing all cubes together.
Remove Ice maker tray and remove one screw on left side holding wire harness cover on. Remove wire harness cover, disconnect wire harness, pull out Ice Maker Assembly. Install new Ice Maker Assembly, plug in new wire harness & screw harness cover back on.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Colby from Midlothian, TX
- Parts Used:
- WR32X10668
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Drawer was left open when doors were shut. Broke one of the pins that holds the drawer cover in place
Removed the clear plexiglass window. Cleaned it with soap and warm water preparing it to be installed into the new Drawer Cover Frame. Re-installed the Plexiglass into the new frame and mounted cover assembly to its fixing place.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Carole from Sunrise, FL
- Parts Used:
- WR32X10662
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
crack by the middle of vegi drwaer
easy slide out and put new one
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Thomas from Pickerington, OH
- Parts Used:
- WR29X10097
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Ice Bucket housing had broken
Simply removed broken part and replaced with new one.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Robert from Arlington Heights, IL
- Parts Used:
- WR32X10666
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Broken pantry flip lid cover
1.) Remove produce drawers above deli drawer. (2). Place right side pin of deli drawer cover into hole. Note that hole on right side has a raised lip so you need to insert this side first. (3). Sprayed PAM cooking spray on deli drawer near hole on left side. (4). Slide left side pin on deli cover into hole on left side. 5 minute job, quite easy. Use cooking spray to lubricate the pin so you don't have to force it into hole on left side and risk breaking it.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Randell from Rancho Cucamonga, CA
- Parts Used:
- MWFP
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Filter needed replacing
Very easy, unscrew and re-screw new filter in..
Was this instruction helpful to you?
Thank you for voting!