PFSS6PKXASS General Electric Refrigerator - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- richard from asheboro, NC
- Parts Used:
- MWFP
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
needed to replace the filter
replaced the filter with the new one i purchased
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- George from Washingtonville, NY
- Parts Used:
- WR32X10668, WR32X10667
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
broken door hinge pin
replaced door and window. Snapped in place
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Andrew from Bensalem, PA
- Parts Used:
- DA81-01345B
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
French spring broke.
pushed new spring in.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Michael from Lebanon, OH
- Parts Used:
- WR32X10668
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- Less than 15 mins
One of the pins holding the frame broke.
I had to remove the clear plastic from the old part and install it on the new frame. I put the plastic in first and could have easily broken a pin. There should be a recommendation to put the frame in when it can bend a little and reduce the chance of breakage again. Put the clear plastic piece back in after the frame is in. That would have been much easier.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Charles from Foresthill, CA
- Parts Used:
- MWFP
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Water Filter Red Light
Replaced Water Filter (twist off old filter; twist on new.)
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Jared from Sandy, UT
- Parts Used:
- WR72X10270
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Factory installed rail was overtightened and fractured the rail. Subsequent use resulted in rail failure.
Remove drawers and internal shelf supported by rail(no tools). Remove rail (phillips). Remove roller from existing rail. Intall roller on new rail. Install new rail (phillips). Replace shelf and drawers. Note: New roller (identified as a separate part) and screws are not included with rail.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Richard from La Grande, OR
- Parts Used:
- MWFP
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
water filter was aged and needed a replacement
unscrew filter and replace the new one
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Clarence M. from Roanoke, VA
- Parts Used:
- WR32X10666
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Side tab broke off
Very easy ,new unit has rollers instead of all plastic sides,just pop- it in, now works better than original.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Dan from Surprise, AZ
- Parts Used:
- MWFP
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
We needed a new water filter.
We received the part just a few days after ordering, unscrewed the old filter by hand, and installed the new filter the same way.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- jane from Pittsford, NY
- Parts Used:
- WR29X10097
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
needed new one
Simply pulled the old one out and slid in new one. Your company had a great price and very fast shipping.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Natalia from Mount Pleasant, SC
- Parts Used:
- MWFP
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Water filter needed replacement
Removed the old filter. Filled the new one with water and put it in theplace of an old one. Flushed the system with 1 gallon of water.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Peter from Homer Glen, IL
- Parts Used:
- WR23X10582
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 1- 2 hours
- Tools:
- Screw drivers
Evaporator freeze up
Pulled off the evaporator cover and replaced the Temp sensor.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- David from San Antonio, TX
- Parts Used:
- MWFP
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Poor water and ice taste, filter a few years old.
Very simple, I followed instructions sent with the filter. Twisted old filter clockwise 1/4 turn to remove. Filled new filter with water, lined up arrow on filter to arrow on refrigerator, and then turned 1/4 turn counterclockwise. Filter raised and seated itself. Wiped few drops of water from refrigerator shelf.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Karen from Medford, MA
- Parts Used:
- WR32X10662, MWFP
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
The plastic on the vegetable tray shelf was cracked
The repair was so easy. I had to take out all the food. Then I was able to easily lift the shelf out, and put the new shelf in and replace the vegetable drawers.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Paul from Chesterfield, VA
- Parts Used:
- WR30X10097
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
icemaker working poorly, almost not at all
I looked at the parts online on Part Select, and determined that the most likely culprit was the icemaker unit itself. The other components did not appear likely to be at fault. Although it cost a bunch ($176)I figured it would be a lot cheaper than hiring someone to come in. The part came amazingly fast, via FedEx second day I think, and I simply looked at the part, and figured out to depress the tabs at the top while pulling the unit toward the front of the fridge, and it came out with moderate effort. One phillips head screw held the door at the left which once removed, allowed the electrical cord to be released after pressing the clip to release the catch. Installation was the reverse, and went really fast. Once connected, the icemaker began making ice after about 1/2 hour, then never stopped after that. Repair complete!! Very pleased.
Was this instruction helpful to you?
Thank you for voting!