PFSF6PKXABB General Electric Refrigerator - Instructions

By hand. It was a very easy fix!

Watched repair video from this site cleaned off shelf, removed the two bins, lifted it out broken shelf, placed new shelf back in, returned the two bins. One step that would have helped a little would have been to remove the bottom door pockets. This would allow the bins to come out easier.

just had to unscrew old one put the new one in

Nothing to tell it was just a replacement part that the old part was removed and the new one inserted. Works like a dream Thanks

If this repair looks hard then you probably aren't doing it right. The key to doing this fairly easy upper hinge replacement is to pry the metal back off of the swinging panel attached to the door as a first step. Doing so exposes the screws that hold the hinges in the panel, and also the tabs that you must press in to release and remove the hinge covers. I accidentally broke the tabs on both hinge covers removing them, but I discovered that it didn't matter - I was still able to snap them both into place without having to replace them as well. Once you've released the hinge covers slide the panel upwards to reveal the entirety of the hinge, then push the hinge up with a flathead screwdriver so that it slides off of the anchor piece on the door. Slide the replacement part down onto the anchor, slide the swinging panel down and replace the hinge covers. From inside the panel reattach the screws (middle hinge only) and replace the panel parts including the metal back. Whole repair takes about 15 minutes.

In order to remove the condenser fan motor I needed to remove the fan blade. The blade is attached to the shaft with a press fit and there is a spring clamp that squeezes the blade to the shaft. Removing the spring clamp did not allow the fan to slide off the shaft because there must be some type of adhesive used in addition to the clamp. In forcing the blade off the shaft expect to damage the fan blade so that is why it was replaced. Very tight working area and difficult to get the leverage to pull on the blade.
The new blade will push on with a bit of force.

I fallow your instruction

This company has everything!! One simple spring was all I needed. Fast shipping and product was exactly what they said I needed. Took me less than a minute to fix!! I’ll definitely shop here again!!

pulled out the plastic cover which by the way is harder then reinstalling it, reinstalled it and had to put one side in and do a little bend in the middle to get the other tab in. just like new and took about 5 - 10 minutes.

thanks
><}}}}*>

removed the clear window and replaced the window into the new pantry cover

I took out the old one and put in the new. 15 seconds.

Used pliers to put new spring in place;
Time took about 3seconds and I’m a female. Video provided very helpful.

Took off the back inside fridge and found that part was frozen with ice and unthawed it took over night al was ok.
Ps turned refrigerator up to 40 degrees all is ok.

Did not put part in : thanks

Placed one end of the new spring in left hole and used the needle nose pliers to insert the other end of the spring in the right hole.

Placed lower spring leg in hole first. Manipulated upper spring leg into upper hole with needle nose pliers.