PFSS6SMXESS General Electric Refrigerator - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- donnie from metairie, LA
- Parts Used:
- MWFP
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
replaced filter
none required
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- david from bridge city, TX
- Parts Used:
- WR13X10516, WR02X12643
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
on the french doors my granddaughter kept turning the inner seal bar when the door was open and when we went to close it it was in the wrong position and eventually the upper hinge broke
I took a small straight screw driver and popped the cap case off, removed old hinge and installed new hinge and snapped the cap back in place.. took all of 30 seconds
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Sharol from Culdesac, ID
- Parts Used:
- WR02X12651
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Spring broke
Installed new spring pin and spring. Took only 2-3 minutes. It was more difficult to get the correct part since the spring pin was the only number listed in the part diagram and I actually needed the spring and had to call customer service to get the correct part number.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Michael from Lebanon, OH
- Parts Used:
- WR32X10668
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- Less than 15 mins
One of the pins holding the frame broke.
I had to remove the clear plastic from the old part and install it on the new frame. I put the plastic in first and could have easily broken a pin. There should be a recommendation to put the frame in when it can bend a little and reduce the chance of breakage again. Put the clear plastic piece back in after the frame is in. That would have been much easier.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Frank from San Diego, CA
- Parts Used:
- WR32X10666
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Flip lid was broken trying to force it open.
I removed the vegetable bins as well as the side panels holding the flip panel. I then tilted the left panel and slipped the side pins in their respective holes. This took some time as it was difficult getting the housing under the drawers to fit back into the side ledges. I was ready to call for a repair serviceman but was proud when the job was completed.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- DENISE from Simpsonville, SC
- Parts Used:
- WR32X10668
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Pin broke off of pantry cover frame
Appreciated others comments before I had to repair mine! Took me a bit to get clear part out of white frame (with screwdriver). Popped clear part into new white frame, but then had to push on some parts to really get it to snap fully in. Then it was simple to put the one pin into the hole on the fridge and bend the frame slightly for the other pin to go in. Thrilled to have it look great and work correctly.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Karen from Medford, MA
- Parts Used:
- WR32X10662, MWFP
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
The plastic on the vegetable tray shelf was cracked
The repair was so easy. I had to take out all the food. Then I was able to easily lift the shelf out, and put the new shelf in and replace the vegetable drawers.
Was this instruction helpful to you?
Thank you for voting!